Lug angles_________________?

Related Mcqs:

1. Efficiency of a riveted joint, having the minimum pitch as per IS : 800, is_________________?

   A. 40% B. 50% C. 60% D. 70%...

2. The slenderness ratio of a column supported throughout its length by a masonry wall is________________?

   A. zero B. 10 C. 100 D. infinity...

3. The slenderness ratio of lacing bars should not exceed________________?

   A. 100 B. 120 C. 145 D. 180...

4. Area of openings for buildings of large permeability is more than_________________?

   A. 10% of wall area B. 20% of wall area C. 30% of wall area D. 50% of wall area...

5. Hudson’s formula gives the dead weight of a truss bridge as a function of_________________?

   A. bottom chord area B. top chord area C. effective span of bridge D. heaviest axle load of engine...

6. In case of plastic design, the calculated maximum shear capacity of a beam as per IS:800 shall be________________?

   A. 0.55 Awfy B. 0.65 Awfy C. 0.75 Awfy D. 0.85 Awfy where, Aw = effective cross-sectional area resisting shear fy = yield stress of the steel...

7. Load factor is____________________?

   A. always equal to factor of safety B. always less than factor of safety C. always greater than factor of safety D. sometimes greater than factor of safety...

8. The portal bracing in a truss bridge is used to_____________________?

   A. transfer load from top of end posts to bearings B. keep the rectangular shape of the bridge cross-section C. stiffen the structure laterally D. prevent the sidesway buckling of top chord...

9. To minimize the total cost of a roof truss, the ratio of the cost of truss to the cost of purlins shall be_______________?

   A. 1 B. 2 C. 3 D. 4...

10. If the 20 mm rivets are used in lacing bars, then the minimum width of lacing bar should be______________?

    A. 40mm B. 60mm C. 80mm D. 100mm...