A. shear
B. bending
C. axial tension
D. shear and bending
Related Mcqs:
- When the bolts are subjected to reversal of stresses, the most suitable type of bolt is________________?
A. black bolt
B. ordinary unfinished bolt
C. turned and fitted bolt
D. high strength bolt - If the thickness of plate to be connected by a rivet is 16 mm, then suitable size of rivet as per Unwin’s formula will be__________________?
A. 16 mm
B. 20 mm
C. 24 mm
D. 27 mm - The actual thickness of butt weld as compared to the thickness of plate is usually________________?
A. more
B. less
C. equal
D. none of the above - The slenderness ratio of lacing bars should not exceed________________?
A. 100
B. 120
C. 145
D. 180 - Area of openings for buildings of large permeability is more than_________________?
A. 10% of wall area
B. 20% of wall area
C. 30% of wall area
D. 50% of wall area - The mechanism method and the statical method give__________________?
A. lower and upper bounds respectively on the strength of structure
B. upper and lower bounds respectively on the strength of structure
C. lower bound on the strength of structure
D. upper bound on the strength of structure - In case of plastic design, the calculated maximum shear capacity of a beam as per IS:800 shall be________________?
A. 0.55 Awfy
B. 0.65 Awfy
C. 0.75 Awfy
D. 0.85 Awfy
where, Aw = effective cross-sectional area resisting shear fy = yield stress of the steel - Other conditions being same, the load factor in indeterminate structures is_______________?
A. equal to load factor in determinate structures
B. more than the load factor in determinate structures
C. less than the load factor in determinate structures
D. unpredictable - Steel tanks are mainly designed for_______________________?
A. weight of tank
B. wind pressure
C. water pressure
D. earthquake forces - For the buildings having a low permeability, the internal wind pressure acting normal to the wall and roof surfaces is taken as__________________?
A. zero
B. ±0.2p
C. ± 0.5 p
D. ±0.7p
where p is basic wind pressure
