A. lesser of 200 mm and 12 t
B. lesser of 200 mm and 161
C. lesser of 300 mm and 32 t
D. lesser of 3 00 mm and 24 t
where t is thickness of thinnest outside plate or angle
Advertisement
Related Mcqs:
- If the thickness of thinnest outside plate is 10 mm, then the maximum pitch of rivets in tension will be taken as______________?
- A. 120 mm B. 160 mm C. 200 mm D. 300 mm...
- Maximum pitch of rivets, used in steel stacks, is limited to_______________?
- A. 6t B. 101 C. 121 D. 161 where t is thickness of thinner plate being connected...
- As compared to field rivets, the shop rivets are________________?
- A. stronger B. weaker C. equally strong D. any of the above...
- Pitch of tacking rivets, when double angles connected back to back and acting as tension members should not be more than_________________?
- A. 500 mm B. 600 mm C. 1000 mm D. 300 mm...
- According to IS Specifications, the effective length of a column effectively held in position at both ends and restrained in direction at one end is taken as________________?
- A. 0.67 L B. 0.8 L C. L D. 1.5 L...
- When the axis of load lies in the plane of rivet group, then the rivets are subjected to________________?
- A. only shear stresses B. only tensile stresses C. both (A) and (B) D. none of the above...
- The difference between gross diameter and nominal diameter for the rivets up to 25 mm diameter is__________________?
- A. 1.0 mm B. 1.5 mm C. 2.0 mm D. 2.5 mm...
- Rivets connecting flange angles to cover plates in a plate girder are subjected to_________________?
- A. horizontal shear only B. vertical load only C. both (A. and (B. D. none of the above...
- For rivets in tension with counter-sunk heads, the tensile value shall be____________________?
- A. reduced by 25 % B. reduced by 33.3% C. increased by 25 % D. increased by 33.3 %...
- If the 20 mm rivets are used in lacing bars, then the minimum width of lacing bar should be______________?
- A. 40mm B. 60mm C. 80mm D. 100mm...
Advertisement
