A. effective throat thickness
B. plate thickness
C. size of weld
D. penetration thickness
Related Mcqs:
- The actual thickness of butt weld as compared to the thickness of plate is usually________________?
A. more
B. less
C. equal
D. none of the above - The effective length of a fillet weld should not be less than___________________?
A. two times the weld size
B. four times the weld size
C. six times the weld size
D. weld size - The basic wind speed is specified at a height ‘h’ above mean ground level in an open terrain. The value of’h’ is__________________?
A. 10 m
B. 20 m
C. 25 m
D. 50 m - In a gusseted base, when the end of the column is machined for complete bearing on the base plate, then the axial load is assumed to be transferred to base plate__________________?
A. fully by direct bearing
B. fully through fastenings
C. 50% by direct bearing and 50% through fastenings
D. 75% by direct bearing and 25% through fastenings - The best arrangement to provide unified behaviour in built up steel columns is by______________?
A. lacing
B. battening
C. tie plates
D. perforated cover plates - Generally the purlins are placed at the panel points so as to avoid__________________?
A. axial force in rafter
B. shear force in rafter
C. deflection of rafter
D. bending moment in rafter - The mechanism method of plastic analysis satisfies___________________?
A. equilibrium and mechanism conditions
B. equilibrium and plastic moment conditions
C. mechanism and plastic moment conditions
D. equilibrium condition only - Lug angles_________________?
A. are used to reduce the length of connection.
B. are unequal angles.
C. increases shear lag.
D. all the above - As per IS : 875, for the purposes of specifying basic wind velocity, the country has been divided into_____________________?
A. 4 zones
B. 5 zones
C. 6 zones
D. 7 zones - Horizontal stiffener in a plate girder is provided to safeguard against_______________?
A. shear buckling of web plate
B. compression buckling of web plate
C. yielding
D. all of the above
