A. ridge board
B. hip rafter
C. eaves board
D. valley rafter
Related Mcqs:
- Higher pitch of the roof (1) results in stronger roof (2) results in weaker roof (3) requires more covering material (4) requires less covering material The correct answer is___________?
A. (1) and (3)
B. (1) and (4)
C. (2) and (3)
D. (2) and (4) - The type of joint commonly used at the junction of a principal rafter and tie beam in timber trussess is__________________?
A. mortise and tennon joint
B. oblique mortise and tennon joint
C. butt joint
D. mitred joint - The function of cleats in a roof truss is______________?
A. to support the common rafter
B. to support purlins
C. to prevent the purlins from tilting
D. all of the above - The function of king post in a king post roof truss is_______________?
A. to support the frame work of the roof
B. to receive the ends of principal rafter
C. to prevent the walls from spreading outward
D. to prevent the tie beam from sagging at its centre - Mansard roof is a roof which slopes in________________?
A. two directions without break in the slope on each side
B. two directions with break in the slope on each side
C. four directions without break in the slope on each side
D. four directions with break in the slope on each side - The lower edge of the pitched roof, from where the rain water of the roof surface drops down, is known as______________?
A. hip
B. gable
C. ridge
D. eaves - The type of roof suitable in plains where rainfall is meagre and temperature is high is______________?
A. pitched and sloping roof
B. flat roof
C. shell roof
D. none of the above - The type of roof which slopes in two directions with a break in the slope on each side is known as_____________?
A. gable roof
B. hip roof
C. gambrel roof
D. mansard roof - Couple close roof is suitable for maximum span of________________?
A. 2.5 m
B. 3.5 m
C. 4.5 m
D. 5.5 m - Couple close roof is suitable for maximum span of______________?
A. 2.5 m
B. 3.5 m
C. 4.5 m
D. 5.5 m
