An ordinate in a funicular polygon represents__________________?

Related Mcqs:

1. A funicular polygon cannot be made to pass through___________________?

   A. one specified point B. two specified points C. three specified points D. more than three specified points...

2. The number of funicular polygons which can be drawn to pass through two specified points in the space diagram are__________________?

   A. zero B. 1 C. 2 D. infinity...

3. If the given forces P,, P2, P3 and P4 are such that the force polygon does not close, then the system will___________________?

   A. be in equilibrium B. always reduce to a resultant force C. always reduce to a couple D. both (A) and (C)...

4. Force polygon method is applicable for_____________________?

   A. any copianar force system B. a system of parallel forces only C. concurrent copianar force system D. non-concurrent copianar force system...

5. The force polygon representing a set of forces in equilibrium is a_____________________?

   A. triangle B. open polygon C. closed polygon D. parallelogram...

6. The angular speed of a car while taking a circular turn of radius 100m at 36 km/hour, is_______________?

   A. 0.1 radian/sec B. 1 radian/sec C. 100 radian/sec D. 1000 radian/sec...

7. If a projectile is fired with an initial velocity of 10 m/sec at an angle of 60° to the horizontal, its horizontal and vertical velocity at the highest point of trajectory are___________________?

   A. 0 and 5 m/sec B. 5 m/sec and 0 C. 5 V3 m/sec and 0 D. 5 and 5V3 m/sec...

8. The maximum pull in a cable, carrying a uniformly distributed load and supported at two ends which are at the same level, is at_____________________?

   A. supports B. quarter span C. mid span D. none of the above...

9. When a body slides down an inclined surface, the acceleration of the body is given by__________________?

   A. g B. gsinG C. g cos 6 D. g tan 6 where ‘g’ is acceleration due to gravity and 9 is the angle of inclination of surface with the horizontal...

10. A particle moves in a straight line and its position is defined by the equation x = 6 t2 – t3 where t is expressed in seconds and x in meters. The maximum velocity during the motion is_________________?

    A. 6 m/sec B. 12 m/sec C. 24 m/sec D. 48 m/sec...