A funicular polygon cannot be made to pass through___________________?

Related Mcqs:

1. An ordinate in a funicular polygon represents__________________?

   A. shear force B. resultant force C. bending moment D. equilibrium...

2. The number of funicular polygons which can be drawn to pass through two specified points in the space diagram are__________________?

   A. zero B. 1 C. 2 D. infinity...

3. If the given forces P,, P2, P3 and P4 are such that the force polygon does not close, then the system will___________________?

   A. be in equilibrium B. always reduce to a resultant force C. always reduce to a couple D. both (A) and (C)...

4. Force polygon method is applicable for_____________________?

   A. any copianar force system B. a system of parallel forces only C. concurrent copianar force system D. non-concurrent copianar force system...

5. The force polygon representing a set of forces in equilibrium is a_____________________?

   A. triangle B. open polygon C. closed polygon D. parallelogram...

6. A flywheel of moment of inertia 20 kg-m” is acted upon by a tangential force of 5 N at 2 m from its axis, for 3 seconds. The increase in angular velocity in radian persecond is__________________?

   A. 1/2 B. 3/2 C. 2 D. 3...

7. A quantity measured in the C.G.S system of units has dimensions M”2L3 T3/2. What numerical factor would be required to convert the quantity to SI units ?

   A. 1 B. 100 C. 1/100 D. 1/10000...

8. If a flywheel increases its speed from 10 rpm to 20 rpm in 10 seconds, then its angular acceleration is_____________________?

   A. —rad/sec 10 B. —rad/sec 20 C. —rad/sec 30 D. none of the above...

9. The graphical method of determining the forces in the members of a truss is based on________________?

   A. method of joint B. method of section C. either method D. none of the two methods...

10. The angle of projection at which the horizontal range and maximum height of a projectile are equal to___________________?

    A. 45° B. tan-1 (2) C. tan-‘ (4) D. tan”1 (1/4)...