A. Chlorine
B. Nitrogen
C. Ethane
D. All the gases will have the same KE
Related Mcqs:
- The accumulation in a steady state combustion process, burning 1 kg mole of carbon with 1 kg mole of oxygen thereby producing 1 kg mole of carbon dioxide, is _____________ kg mole?
A. 1
B. 0
C. 16
D. 44 - The ratio of existing moles of vapor per mole of vapor free gas to the moles of vapor that would be present per mole of vapor free gas, if the mixture were saturated at the existing temperature & pressure, is termed as the_____________________?
A. Relative humidity
B. Relative saturation
C. Percentage saturation
D. None of these - One mole of methane undergoes complete combustion in a stoichiometric amount of air. The reaction proceeds as CH4 + 2O2 → CO2 + 2H2O. Both the reactants and products are in gas phase. ΔH°298 = – 730 kJ/mole of methane. Mole fraction of water vapour in the product gases is about_____________________?
A. 0.19
B. 0.33
C. 0.40
D. 0.67 - At standard conditions, N2 + 2O2 ⇌ 2NO2; ΔG° = 100 kJ/mole NO + ½O2 ⇌ 2NO2; ΔG° = -35 kJ/mole The standard free energy of formation of NO in kJ/mole is___________________?
A. 15
B. 30
C. 85
D. 170 - What is the total pressure exerted by a mixture of 0.45 kg mole of benzene, 0.44 kg mole of toluene and 0.23 kg mole of o-xylene at 100°C, if their vapor pressures at 100°C are 1340, 560 and 210 mmHg respectively ?
A. 756.2
B. 780.5
C. 801.5
D. 880.5 - A car tyre of volume 0.057 m3 is inflated to 300 kPa at 300 K. After the car is driven for 10 hours, the pressure in the tyre increases to 330 kPa. Assume air is an ideal gas and Cv for air is 21 J/mole.K. The change in the internal energy of air in the tyre in J/mole is__________________?
A. 380
B. 630
C. 760
D. 880 - The combustion equations of carbon and carbon monoxide are as follows: C + O2 = CO2, ΔH = – 394 kJ/kg .mole CO + ½ O2 = CO2, ΔH = – 284.5 kJ/kg. mole. The heat of formation of CO is _____________ kJ/kg. mole?
A. -109.5
B. +109.5
C. +180
D. +100 - A very dilute solution is prepared by dissolving ‘x1’ mole of solute in ‘x2’ mole of a solvent. The mole fraction of solute is approximately equal to_________________?
A. x1/x2
B. x2/x1
C. 1 – (x1/x2)
D. 1/x2 - A fluid gas produced on burning furnace oil contains 0.15 gm mole of CO2, 0.05 gm mole of oxygen and 0.80 gm mole of N2. What is its molecular weight ?
A. 28.6
B. 30.0
C. 30.6
D. 32.6 - A butane isomerisation process produces 70 k.mole/hr of pure iso-butane. A purge stream removed continuously, contains 85% n-butane and 15% impurity (mole%). The feed stream is n-butane containing 1% impurity (mole%). The flow rate of the purge stream will be_________________?
A. 3 kmole/hr
B. 4 kmole/hr
C. 5 kmole/hr
D. 6 kmole/hr
