A. High spalling resistance
B. Low spalling resistance
C. High resistance to fusion
D. Low porosity
Related Mcqs:
- Refractoriness under load (RUL) is the most important property for the refractory bricks_________________?
A. At the hearth bottom of the furnace on which stock is placed
B. Used for furnace insulation
C. Used in the roof of the furnace
D. None of these - Which of the following impurities reduces the refractoriness of magnesite bricks ?
A. Al2O3
B. CaO
C. SiO2
D. All A., B. & C. - . Refractoriness under load (RUL) of fireclay bricks (under a load of 2 kg/cm2) is ______________ °C?
A. 500
B. 1000
C. >1350
D. >2000 - Refractoriness under loads (RUL) is quite close to the fusion temperature (PCE) for _____________ bricks?
A. Fireclay
B. Silica
C. Dolomite
D. Very low alumina - High porosity refractory bricks have _______________?
A. Poor resistance to the penetration of molten slag, metal & flue gases
B. Poor heat conductivity & low strength
C. Better thermal spalling resistance
D. All A., B. and C. - High density refractory bricks have lower__________________?
A. Spalling resistance
B. Thermal conductivity
C. Fusion point
D. Slag penetration resistance - High alumina refractory compared to fireclay bricks have____________________?
A. Less load bearing capacity
B. Less resistance to slag attack
C. Low refractoriness
D. High resistance to thermal shock and creep - Sillimanite (Al2O3.SiO2) refractory, which is a neutral refractory, is not used in________________?
A. Pottery furnace
B. Glass melting furnace
C. Crucibles
D. Gas retorts - Water content in ground refractory material to be shaped into bricks by hand moulding is about ______________ percent?
A. 5
B. 20
C. 40
D. 55 - Refractory bricks with lower permeability is produced by using __________________?
A. Higher firing temperature
B. Higher moulding pressure
C. Finer grog size
D. All A., B. and C.
