A. 2
B. ½
C. 4
D. 8
Related Mcqs:
- The average velocity in the tubes of a 1-4 heat exchanger is ______________ times that in 1-1 heat exchanger having the same size & number of tubes and operated at same liquid flow rate ?
A. 2
B. 1/2
C. 4
D. 1/4 - In a shell and tube heat exchanger, the overall heat transfer co-efficient is proportional to the tube side (volumetric flow rate)0.8. This is valid, only when the ratio of the tube side film resistance to the total resistance is almost equal to____________________?
A. ∞
B. 1
C. 20.8
D. 2 - If a single tube pass heat exchanger is converted to two passes; for the same flow rate, the pressure drop per unit length in tube side will _____________ times?
A. Increase by 1.8
B. Decrease by 22
C. Increase by 21.6
D. None of these - Tube wall thickness depends on the corrosiveness of the fluids and their operating pressure & temperature and is specified by Birmingham wire gauge (B.W.G)-a number which varies from 8 to 18 with the numbers 14 and 16 being more commonly used. Outside diameter of tubes varies from about 15 to 50 mm; however a tube of less than _____________ mm outside diameter is generally not recommended for fouling fluids ?
A. 16
B. 19
C. 28
D. 38 - Tube side heat transfer co-efficient for turbulent flow of liquid through tubes is proportional to___________________?
A. G0.2
B. G0.5
C. G0.8
D. G1.5 - In a shell and tube heat exchanger for a given heat transfer surface area, smaller diameter tubes are favoured as compared to larger diameter ones; because the smaller diameter tubes ______________?
A. Are easier to clean
B. Are less prone to fouling
C. Can be fitted into a smaller shell diameter hence the cost of the heat exchanger would be less
D. None of these - In a shell and tube heat exchanger having square pitch, the shell side equivalent diameter is given by (where, P = pitch, d = outside diameter of the tube) ?
A. 4(P2 – πd2/4)/πd
B. (P2 – rd2/4)/rd
C. 4P2/πd
D. πd/4P2 - The shell side pressure drop in a shell and tube heat exchanger is maximum for _______________ baffle?
A. Disk and ring
B. Segmental
C. Orifice
D. Independent of the type of - Tubes are fixed to the tube sheet (a thick circular metallic plate) by the method of tube rolling and brazing (non-removable) or ferrule connection (removable). Thickness of the tube, sheet is normally ____________ the outside diameter of the tube but in no case it should be less than 22 mm (7/8″)?
A. Half
B. Three fourth
C. Equal to
D. 1.5 times - The clearance between two tubes in a shell and tube heat exchanger is known as ‘ligament’, whose minimum value is _____________ the outside diameter of the tube, but in no case it should be less than 4.5 mm?
A. Equal to
B. Half
C. One fourth
D. Three fourth
