A. < 12.5
B. > 3
C. > 5
D. 5-10
Related Mcqs:
- For a cylindrical vessel of moderate height, the weld joint efficiency for joints parallel to the cylindrical axis is given as 1.0; while for joints along the girth (circumference) it is given as 0.8. In calculating the shell wall thickness using code formula for an internally pressurised cylindrical vessel, what value of weld joint efficiency should be used ?
A. 0.8
B. 0.9
C. 1.0
D. (0.8)0.5 - The thickness of segmental baffles (25 -35% cut truncated plates usually) is generally _____________ the tube wall thickness?
A. Equal to
B. Twice
C. Four times
D. Half - In case of plain carbon steel, butt welded joints are used for shell plate thickness ≤ _____________ cms?
A. 1.2
B. 0.5
C. 3.8
D. 6.8 - The thickness of heat transfer plates used in the plate type heat exchanger ranges from _____________ mm, pressed in a single piece provided with grooves & corrugations?
A. 0.3 to 0.8
B. 1.25 to 3.125
C. 3.5 to 7.0
D. 8 to12 - Thickness of the frame of a plate and frame filter as compared to that of plates is___________________?
A. Less
B. Same
C. More
D. Either A. or B. - Large process vessels operating under extreme temperature and pressure conditions are normally clad/ lined with materials like stainless steel, aluminium, nickel & its alloys, copper & its alloys and titanium. The cladding thickness is generally about ______________ percent of the total thickness?
A. 1 to 5
B. 10 to 20
C. 30 to 40
D. 40 to 50 - For a cylindrical shell, (subject to the thickness of uppermost course being more than the minimum for dia of the tank in question), the thickness of the courses of shell_________________?
A. Decreases upwards
B. Increases upwards
C. Remains same throughout
D. May decrease or increase upwards depending upon whether vacuum or positive pressure
would be maintained inside the shell - Generally, no corrosion allowance in wall thickness of a part is required, if the thickness is more than ______________ mm?
A. 10
B. 20
C. 30
D. 5 - For a 25 mm hole drilled in plates to be riveted, the shank diameter of the rivet should be _______________ mm?
A. 25
B. 23
C. 26
D. 27 - Angled baffles are preferred in the agitation tank to control the swirling action; if the viscosity of the liquid to be mixed is about 200 poise. However, the baffle may be completely eliminated for mixing liquids having viscosity above ____________________ poise?
A. 300
B. 600
C. 1000
D. 1500
