A. Flow rates of each fluid
B. Type and size of packing
C. Concentration of each fluid
D. All A, B. & C.
Related Mcqs:
- Overall mass transfer co-efficient in case of absorption of __________ in water is based on the gas film co-efficient only, as the mass transfer process is gas film (phase) controlling ?
A. CO2
B. SO2
C. NH3
D. None of these - An increase in the liquid resistance to interphase mass transfer and a resultant reduction in plate efficiency is caused by______________?
A. An increase in liquid viscosity
B. An increase in relative volatility for rectification columns
C. Decrease in gas solubility for absorbers
D. All A., B. and C. - The practical representative values of HETP for a number of commercial operations lies within a range of ______________ metre?
A. 0.1-0.2
B. 0.2-0.5
C. 0.4-0.9
D. 1.2-1.5 - A high vapour velocity is required for high plate efficiency in a sieve plate column. The satisfactory value of operating vapor velocity for design purpose in sieve plate column is about _______________ percent of the flooding velocity?
A. 45
B. 60
C. 80
D. 95 - What is the slope of the operating line in the stripping section of a distillation column ?
A. 0
B. ∞
C. > 1
D. < 1 - The operating velocity in the absorption tower is usually 40-50% of the flooding velocity. Packed absorption towers are normally designed for a pressure drop of about _________________ mm of water column per metre height of packing?
A. 1-5
B. 20-40
C. 100-150
D. 1000-1500 - For annular flow of a fluid, the ratio of the equivalent diameter for pressure drop calculation to the equivalent diameter for heat transfer calculation is_________________?
A. d1/(d1 + d2)
B. d2/(d1 + d2)
C. (d1 + d2)/d1
D. (d1 + d2)/d2 - Pressure drop (Δp) and the superficial gas mass velocity (G) in case of packed absorption tower operating in the preloading range are related as_________________?
A. Δp = G
B. Δp = G0.5
C. Δp = G2
D. Δp = 1/G0.6 - Which of the following factors affect the pressure drop in a co-current gas-liquid absorption packed tower ?
A. Size, shape, orientation and surface of the packing particles
B. Density and viscosity of fluids
C. Fluid flow rates
D. All A., B. and C. - Mc Cable Thiele method used for finding theoretical stages in a distillation column assumes that the_____________________?
A. Sensible heat differences are small, because the temperature changes from tray to tray is small
B. Trouton’s rule is applicable
C. Liquid/vapor loading across the column remains constant
D. All A., B. and C.