A ‘rupture disc’ is provided in chemical equipments as an accessory meant for ___________________?

Related Mcqs:

1. Safety valves are provided in chemical equipments to guard against excessive_________________?

   A. Temperature
   B. Pressure/pressure fluctuation
   C. Turbulence
   D. Noise

2. Apex angle of conical heads used in the bottom heads of chemical process equipments is usually__________________?

   A. 30°
   B. 45°
   C. 60°
   D. 75°

3. Factor of safety (i.e., overdesign factor) in heat transfer equipments is about _____________ percent more than the actual/theoretical design factor?

   A. 5-10
   B. 15-20
   C. 30-35
   D. 35-40

4. For high pressure process equipments/vessels, the connected nozzle should be____________________?

   A. Welded
   B. Screwed
   C. Flanged
   D. Brazed

5. Lug support is meant for supporting _______________ vessels?

   A. Large horizontal cylindrical
   B. Tall but empty
   C. Small
   D. Thick walled tall

6. Accidents in chemical plants are mostly due to___________________?

   A. Inadequate equipment design
   B. Faulty operating procedures
   C. Improper layout of the equipments
   D. Failure of equipments

7. The safe distance of habitation from a hazardous chemical plant (TLV of its product < 1000 ppm) should be about ______________ kms?

   A. 1
   B. 5
   C. 15
   D. 25

8. Corrosion allowance in the design of pressure vessel/chemical equipment is not necessary, if___________________?

   A. Plain carbon steel and cast iron parts are used
   B. Wall thickness is > 30 mm
   C. Material of construction is high alloy steel
   D. Both B. & C.

9. Fresh water carrying pipelines in chemical industries are coloured with _______________ color?

   A. Sea green
   B. Brown
   C. Yellow
   D. Red

10. Welded joint efficiency in the design of chemical process equipment is taken as_________________?

    A. 0.55
    B. 0.75
    C. 0.85
    D. 0.95