A. Blow moulding
B. Vacuum thermo forming
C. Injection moulding
D. None of these
Related Mcqs:
- Plastic articles are normally produced by _____________ moulding?
A. Green sand
B. Injection
C. Shell
D. Dry sand - The process involved in converting rubber into a thin sheet or coating it on fabric is called__________________?
A. Extrusion
B. Mastication
C. Calendaring
D. Vulcanisation - Polystyrene is a ____________ plastic at room temperature?
A. Ductile
B. Brittle
C. Malleable
D. None of these - Flexible plastic pipes are made of___________________?
A. High density polyethylene (HDPE)
B. Low density polyethylene (LDPE)
C. Polypropylene
D. Unsaturated polyester - Plasticisers are high boiling liquids added to plastic polymers to impart toughness and flexibility at ordinary temperature. Which of the following is not a plasticiser ?
A. Ethylene glycol
B. Stearic acid estors
C. Tricresyl phosphate
D. Esters of phthalic acid - _____________ is a thermosetting plastic ?
A. PVC
B. Polythene
C. Bakelite
D. Polystyrene - Thermocol is a spongy, porous, rigid or flexible foamed plastic, obtained by blowing gas/air through molten__________________?
A. Saturated polyester
B. Polyurethane
C. Polystyrene
D. Either B. or C. - Thermosetting plastic materials___________________?
A. Can be repeatedly melted
B. Is useful for melt casting
C. Cannot be melted after forming
D. Is useful for spinning - Which of the following is the lowest cost plastic commercially available ?
A. Polythene
B. Teflon
C. Bakelite
D. PVC - Plastic tubes & pipes are generally made by ______________ moulding?
A. Injection
B. Transfer
C. Extrusion
D. Compression
