A. Dust & mists
B. Smoke & fumes
C. Photochemical smog & soot
D. None of these
Related Mcqs:
- Very small amount of air pollutants are present in stratosphere also; though most of the atmospheric pollutants are present in the troposphere. Which of the following atmospheric pollutants does not cause the ozone layer depletion in atmosphere at tremendous rate ?
A. CO
B. SO2
C. NOx
D. CFC (chloro fluoro carbons) - Which of the following is the most efficient for removal of very finely divided suspended solids and colloidal matter from the polluted water stream ?
A. Sedimentation tank
B. Circular clarifier
C. Mechanical flocculation
D. Chemical coagulation - As per the world health organisation (WHO) specification, the maximum permissible concentration (i.e., TLV) of particulate matter in air is _____________ μg/m3.(μg-microgram)?
A. 10
B. 90
C. 800
D. 750 - In reactions involving solids and liquids (where change in volume is negligible), the heat of reaction at constant pressure as compared to that at constant volume is_______________?
A. More
B. Less
C. Same
D. Unpredictable; depends on the particular reaction - Which of the following air pollutants is not toxic to vegetation i.e., doesn’t cause vegetation damage ?
A. Smog & ozone
B. Hydrogen fluoride & nitrogen oxides
C. Sulphur dioxide & spray of weed killers
D. Carbon monoxide - Which of the following is the most major constituents of air pollutants ?
A. Oxides of sulphur
B. Oxides of nitrogen
C. Carbon monoxide
D. Hydrogen sulphide - Carcinogenic air pollutants cause__________________?
A. Bone decay
B. Cancer
C. Asphyxiation (suffocation)
D. Anemia - High concentration of carcinogenic hydrocarbon pollutants in atmospheric air causes____________________?
A. Cancer
B. Silicosis
C. Respiratory disease (e.g., asthma)
D. Reduced crop yield - Most of the atmospheric air pollutants are present in large quantity in__________________?
A. Stratosphere
B. Thermosphere
C. Troposphere
D. Mesosphere - Pollution by particulate matter emission in the atmosphere does not take place during metal____________________?
A. Grinding
B. Machining
C. Cutting
D. Polishing