A. Improve machinability & tensile strength
B. Remove internal stresses
C. Refine the structure
D. Remove strains caused by cold working
Related Mcqs:
- Normalising does not _____________________ of a metal?
A. Improve machinability & tensile strength
B. Remove internal stresses
C. Refine the structure
D. Remove strains caused by cold working - ______________________ is used as a material of construction for the blade of power saw ?
A. Wrought iron
B. Stainless steel
C. Mild steel
D. High speed steel - The escape velocity of a body on earth which is independent of its mass is about ______________________ km/second?
A. 3
B. 7
C. 11
D. 15 - A reasonably general expression for vapour-liquid phase equilibrium at low to moderate pressure is φi yi P = Yi xifi° where, Φ is a vapor fugacity component, Yi is the liquid activity coefficient and fi° is the fugacity of the pure component i. the Ki value (Yi = Ki xi) is therefore, in general a function of ______________________?
A. Temperature only
B. Temperature and pressure only
C. Temperature, pressure and liquid composition xi only
D. Temperature, pressure, liquid composition xi and vapour composition yi - The expression for entropy change given by, ΔS = nR ln (V2/V1) + nCv ln (T2/T1) is valid for ______________________?
A. Reversible isothermal volume change
B. Heating of a substance
C. Cooling of a substance
D. Simultaneous heating and expansion of an ideal gas - Co-efficient of Performance (COP) of a refrigerator is the ratio of the ______________________?
A. Work required to refrigeration obtained
B. Refrigeration obtained to the work required
C. Lower to higher temperature
D. Higher to lower temperature - Filler material used in welding should have _________________ as compared to the parent metal to be welded ?
A. Lower melting temperature
B. Same melting temperature
C. Same composition
D. Both ‘B’ & ‘C’ - Fatigue limit improvement by over stressing the metal by successively increasing the load is called coaxing. In fatigue failure, the material fails ?
A. Below the yield point
B. Above the yield point
C. Below the elastic limit
D. At the elastic limit - Which of the following hardness tests does not measure the indentation hardness of metals and alloys ?
A. Vickers hardness test
B. Shore scleroscope test
C. Brinell hardness test
D. Rockwell hardness test - For the gaseous phase chemical reaction, C2H4(g) + H2O(g) ↔ C2H5OH(g), the equilibrium conversion does not depend on the________________?
A. Steam to ethylene ratio
B. Temperature
C. Pressure
D. None of these