Size reduction of the ______________ can be suitably done by ball mills, crushing rolls and rod mills?

Related Mcqs:

1. Theoretical capacity of crushing rolls in tons/hr is given by (where, V = peripheral velocity, m/sec. W = width of rolls, m Dr = distance between rolls ρ = density of material to be crushed, kg/m3 here, V =πND where, N = speed of the rolls in rotation per second (rps) D = diameter of rolls, m) ?

   A. 3.6 V.W.Dr.ρ
   B. 3.6 V.W. ρ
   C. 3.6 W.Dr.ρ
   D. 3.6 V.W.Dr/ρ

2. Ball mills and tube mills with flint or porcelain balls are used for size reduction of_______________?

   A. Asbestos
   B. Rubber
   C. Non-metallic ores
   D. Limestone

3. Half the angle of nip, (α), for a roll crusher is given by (where, dr, dp and df are diameters of crushing rolls, feed particles and rolls gap respectively) ?

   A. cos α = (dr + dp)/(dr + df)
   B. cos α = (dr + df)/(dr + dp)
   C. tan α = (dr + dp)/(dr + df)
   D. sin α = (dr + dp)/(dr + df)

4. What is the usual value of angle of nip for crushing of ordinary rock in smooth steel crushing rolls?

   A. 16°
   B. 32°
   C. 40°
   D. 46°

5. In a size reduction crushing operation, feed size is 300 to 1500 mm while the product size is 100 to 300 mm. This is a case of the ________________ crushing?

   A. Secondary
   B. Fine
   C. Primary
   D. Ultrafine

6. In a size reduction crushing operation, feed size is 100 to 300 mm. while the product size is 10 to 50 mm. This is a case of the _____________ crushing?

   A. Primary
   B. Secondary
   C. Fine
   D. Ultrafine

7. In a size reduction crushing operation, the feed size is 10 to 50 mm, while the product size is 2 to 10 mm. This is a case of _______________ crushing?

   A. Primary
   B. Secondary
   C. Fine
   D. Ultrafine

8. For achieving maximum capacity of the ball mill, the ball charge should be equal to about ______________ percent of the ball mill volume?

   A. 10
   B. 25
   C. 50
   D. 75

9. ____________ mills fall in the category of tumbling mills ?

   A. Ball and pebble
   B. Rod and tube
   C. Compartment
   D. All A., B. & C.

10. Pebble mills are tumbling mills widely used for grinding in the manufacture of paints & pigments and cosmetic industries, where iron contamination in the product is highly objectionable. Pebbles used in pebble mill are made of__________________?

    A. Bronze
    B. Stainless steel
    C. Flint or porcelain
    D. Concrete