A. Pug mill
B. Mixer-extruder
C. Banbury mixer
D. Muller mixer
Related Mcqs:
- The energy required per unit mass to grind limestone particles of very large size to 100 μm is 12.7 kWh/ton. An estimate (using Bond’s law) of the energy to grind the particles from a very large size to 50 μm is________________?
A. 6.35 kWh/ton
B. 9.0 kWh/ton
C. 18 kWh/ton
D. 25.4 kWh/ton - Limestone is normally crushed in a _____________________?
A. Roll crusher
B. Hammer crusher
C. Ball mill
D. Tube mill - Dispersion of a gas through liquid is done by using a__________________?
A. Sparger
B. Kneader
C. Masticator
D. None of these - For grinding of cereals, grains, spices, pigments, saw dust, cork etc., the most extensively used size reduction equipment is a__________________?
A. Buhrstone mill
B. Ball mill
C. Crushing rolls
D. Hammer mill - Fibrous material is broken by a__________________?
A. Roll-crusher
B. Squirrel-cage disintegrator
C. Ball mill
D. Tube mill - _____________ are mixed using ribbon blenders ?
A. Lumpy solids and low viscosity liquids
B. Dry powders
C. High viscosity liquids
D. Thick pastes - The optimum moisture content in solids to be crushed/ground ranges from _______________ percent?
A. 3 to 4
B. 8 to 10
C. 10 to 15
D. 15 to 20 - Wheat is ground into flour in a___________________?
A. Hammer crusher
B. Roller crusher
C. Impact mill
D. Fluid energy mill - Energy requirement (per unit mass of material crushed/ground) is highest for__________________?
A. Jaw crusher
B. Rod mill
C. Ball mill
D. Fluid energy mill - Basic slag is not ground in_________________?
A. Jaw crushers
B. Ball mills
C. Compartment mills
D. Tube mills