A. Tunnel
B. Tray
C. Rotary
D. None of these
Related Mcqs:
- A solid is being dried in the linear drying rate regime from moisture content Xo to XF. The drying rate is zero at X = 0 and the critical moisture content is the same as the initial moisture Xo. The drying time for M = (Ls/ARc) is (where, L = total mass of dry solid, A = total surface area for drying Rc = Constant maximum drying rate per unit area X = moisture content (in mass of water/mass of dry solids)) ?
A. M(Xo – XF)
B. M(Xo/XF)
C. M ln(Xo/XF)
D. MXo ln(Xo/XF) - A solid is being dried in the linear drying rate regime from moisture content Xo to XF. The drying rate is zero at X = 0 and the critical moisture content is the same as the initial moisture Xo. The drying time for M = (Ls/ARc) is (where, L = total mass of dry solid, A = total surface area for drying Rc = Constant maximum drying rate per unit area X = moisture content (in mass of water/mass of dry solids))_____________?
A. M(Xo – XF)
B. M(Xo/XF)
C. M ln(Xo/XF)
D. MXo ln(Xo/XF) - A 25 cm × 25 cm × 1 cm flat sheet weighing 1.2 kg initially was dried from both sides under constant drying rate conditions. It took 1500 seconds for the weight of the sheet to reduce to 1.05 kg. Another 1m × 1m × 1cm flat sheet of the same material is to be dried from one side only. Under the same constant drying rate conditions, the time required for drying (in seconds) from its initial weight of 19.2 kg to 17.6 kg is ____________________?
A. 1000
B. 1500
C. 2000
D. 2500 - Advantage of continuous drying over batch drying is that the_____________________?
A. Drying cost per unit weight of dried product is less
B. Product with more uniform moisture content is produced
C. Equipment size required is smaller
D. All A , B. & C. - Large scale drying of sugar is done in a _______________ dryer?
A. Spouted bed
B. Tray
C. Rotary
D. Truck - For achieving rapid drying rate in a spray dryer, the diameter of the particles in the feed should be in the range of _______________ microns (1 mm = 1000 microns)?
A. 1-5
B. 10-60
C. 200-300
D. > 500 - Dryer widely used in a textile industry is ______________ dryer?
A. Festoon
B. Cylinder
C. Conveyor
D. Tunnel - A solid material shows case hardening properties while drying. Which of the following should be controlled to control the drying process ?
A. Flow rate of inlet air
B. Relative humidity of outlet air
C. Humidity of inlet air
D. Temperature of the solid - Occurrence of ‘case hardening’ during drying of a high moisture solid cake _______________ the drying rate?
A. Increases
B. Decreases
C. Does not affect
D. Exponentially increases - Large scale drying of wheat is done in a ________________ dryer?
A. Fluidised bed
B. Spouted bed
C. Tray
D. Vacuum rotary
