Internal energy of an element at 1 atm and 25° C is ____________ kcal/kg.mole?

Related Mcqs:

1. The theoretical minimum work required to separate one mole of a liquid mixture at 1 atm, containing 50 mole % each of n- heptane and n- octane into pure compounds each at 1 atm is__________________?

   A. -2 RT ln 0.5
   B. -RT ln 0.5
   C. 0.5 RT
   D. 2 RT

2. Consider the equilibrium A(g) + B(g) = AB(g). When the partial pressure of A is 10-2 atm, the partial pressure of B is 10-3 atm and the partial pressure of AB is 1 atm, the equilibrium constant ‘K’ is____________________?

   A. 10 atm-1
   B. 105 atm-1
   C. 10 (dimensionless)
   D. 105 (dimensionless)

3. The accumulation in a steady state combustion process, burning 1 kg mole of carbon with 1 kg mole of oxygen thereby producing 1 kg mole of carbon dioxide, is _____________ kg mole?

   A. 1
   B. 0
   C. 16
   D. 44

4. If heat contents of CH4, C2H4 and C3H8 are -17.9, 12.5 and -24.8 kcal/mole respectively, than ΔH for the reaction CH4(g) + C2H4(g) ⇌ C3H8(g) will be _____________ Kcal?

   A. -19.4
   B. -30.2
   C. 55.2
   D. -55.2

5. A car tyre of volume 0.057 m3 is inflated to 300 kPa at 300 K. After the car is driven for 10 hours, the pressure in the tyre increases to 330 kPa. Assume air is an ideal gas and Cv for air is 21 J/mole.K. The change in the internal energy of air in the tyre in J/mole is__________________?

   A. 380
   B. 630
   C. 760
   D. 880

6. The combustion equations of carbon and carbon monoxide are as follows: C + O2 = CO2, ΔH = – 394 kJ/kg .mole CO + ½ O2 = CO2, ΔH = – 284.5 kJ/kg. mole. The heat of formation of CO is _____________ kJ/kg. mole?

   A. -109.5
   B. +109.5
   C. +180
   D. +100

7. A very dilute solution is prepared by dissolving ‘x1’ mole of solute in ‘x2’ mole of a solvent. The mole fraction of solute is approximately equal to_________________?

   A. x1/x2
   B. x2/x1
   C. 1 – (x1/x2)
   D. 1/x2

8. A fluid gas produced on burning furnace oil contains 0.15 gm mole of CO2, 0.05 gm mole of oxygen and 0.80 gm mole of N2. What is its molecular weight ?

   A. 28.6
   B. 30.0
   C. 30.6
   D. 32.6

9. A butane isomerisation process produces 70 k.mole/hr of pure iso-butane. A purge stream removed continuously, contains 85% n-butane and 15% impurity (mole%). The feed stream is n-butane containing 1% impurity (mole%). The flow rate of the purge stream will be_________________?

   A. 3 kmole/hr
   B. 4 kmole/hr
   C. 5 kmole/hr
   D. 6 kmole/hr

10. The vapour pressure of water is given by, in Psat = A – (5000/T), where A is a constant, Psat is the vapour pressure in atm. and T is the temperature in K. The vapor pressure of water in atm. at 50°C is approximately__________________?

    A. 0.07
    B. 0.09
    C. 0.11
    D. 0.13