Heat is added at constant pressure in an ideal _____________ cycle?

Related Mcqs:

1. Heat is added at constant temperature in an ideal ______________ cycle?

   A. Stirling
   B. Brayton
   C. Rankine
   D. None of these

2. Pressure-enthalpy chart is useful in refrigeration. The change in internal energy of an ideal fluid used in ideal refrigeration cycle is_____________________?

   A. Positive
   B. Negative
   C. Zero
   D. Infinity

3. Fugacity of a component in an ideal gas mixture is equal to the partial pressure of that component in the mixture. The fugacity of each component in a stable homogeneous solution at constant pressure and temperature ____________ as its mole fraction increases?

   A. Decreases
   B. Decreases exponentially
   C. Increases
   D. Remain constant

4. 1m3 of an ideal gas at 500 K and 1000 kPa expands reversibly to 5 times its initial volume in an insulated container. If the specific heat capacity (at constant pressure) of the gas is 21 J/mole . K, the final temperature will be ?

   A. 35 K
   B. 174 K
   C. 274 K
   D. 154 K

5. In reactions involving solids and liquids (where change in volume is negligible), the heat of reaction at constant pressure as compared to that at constant volume is_______________?

   A. More
   B. Less
   C. Same
   D. Unpredictable; depends on the particular reaction

6. An ideal gas is taken around the cycle ABCA as shown in P-V diagram below: The work done by the gas during the cycle is equal to_________________?

   A. 12 P1V1
   B. 6 P1 V1
   C. 3 P1V1
   D. P1 V1

7. Answer: Option B 392. Keeping the pressure constant, to double the volume of a given mass of an ideal gas at 27°C, the temperature should be raised to _____________ °C?

   A. 270
   B. 327
   C. 300
   D. 540

8. Consider the equilibrium A(g) + B(g) = AB(g). When the partial pressure of A is 10-2 atm, the partial pressure of B is 10-3 atm and the partial pressure of AB is 1 atm, the equilibrium constant ‘K’ is____________________?

   A. 10 atm-1
   B. 105 atm-1
   C. 10 (dimensionless)
   D. 105 (dimensionless)

9. The vapour pressure of water is given by, in Psat = A – (5000/T), where A is a constant, Psat is the vapour pressure in atm. and T is the temperature in K. The vapor pressure of water in atm. at 50°C is approximately__________________?

   A. 0.07
   B. 0.09
   C. 0.11
   D. 0.13

10. A perfectly insulated container of volume V is divided into two equal halves by a partition. One side is under vacuum, while the other side has one mole of an ideal gas (with constant heat capacity) at 298 K. If the partition is broken, the final temperature of the gas in the container___________________?

    A. Will be greater than 298 K
    B. Will be 298 K
    C. Will be less than 298 K
    D. Cannot be determined