A. By-product coke oven
B. Calcination kiln
C. Sintering furnace
D. Open hearth furnace
Related Mcqs:
- Which of the following is a directly fired intermittent furnace ?
A. Walking beam reheating furnace
B. Reverberatory furnace
C. Tower furnace
D. Tunnel kiln - While the fuel fired furnace can be used upto a maximum temperature of about 1700°C, the electric furnace can be used upto a temperature of about _____________ °C?
A. 2000
B. 3000
C. 4500
D. 6000 - Combustion of furnace oil in a furnace (soaking pit) with preheated combustion air at 400°C results in saving of about __________ percent furnace oil as compared to its combustion with atmospheric air, if the flue gas outlet temperature from the soaking pit is 1200°C ?
A. 5
B. 60
C. 20
D. 40 - Temperature of a furnace fired with low calorific value fuel gas (i.e. lean gas) can be increased by______________________?
A. Preheating the combustion air
B. Oxygen enrichment of combustion air
C. Preheating the fuel gas
D. All A., B. & C. - Oxygen percentage in the flue gas coming out of a gaseous fuel fired furnace should be ideally about _____________ percent?
A. < 2
B. < 5
C. < 8
D. < 10 - Overall thermal efficiency of a lumpy coal fired suitably designed heating furnace, if operated & maintained properly may be about ____________ percent?
A. 10-15
B. 25-30
C. 45-50
D. 65-70 - Furnace aerodynamics is related to the _____________ in the furnace?
A. Movement of gases
B. Measurement of flue gas volume
C. Temperature control
D. Pressure adjustment - The electric furnace in which heat is produced by a combination of induced current and skin effect is called _____________ furnace?
A. Arc
B. Resistance
C. Low frequency induction
D. High frequency induction - Which furnace employs an I.D. fan for the removal of flue gases from the furnace ?
A. Coke oven
B. Blast furnace stoves
C. Beehive coke oven
D. High pressure boiler - Higher furnace temperature cannot be achieved by use of a lean fuel gas in the furnace by_________________?
A. Increasing the draft in the furnace
B. Preheating the fuel gas
C. Oxygen enrichment of combustion air
D. Preheating the combustion air
