A. Soaking pit
B. Reheating furnace
C. Open hearth furnace
D. Cupola
Related Mcqs:
- Combustion of furnace oil in a furnace (soaking pit) with preheated combustion air at 400°C results in saving of about __________ percent furnace oil as compared to its combustion with atmospheric air, if the flue gas outlet temperature from the soaking pit is 1200°C ?
A. 5
B. 60
C. 20
D. 40 - Which furnace employs an I.D. fan for the removal of flue gases from the furnace ?
A. Coke oven
B. Blast furnace stoves
C. Beehive coke oven
D. High pressure boiler - Soaking pits are meant for heating steel_________________?
A. Ingots
B. Coils
C. Sheets
D. Slabs - In furnaces operating at very high temperature (say) 1250°C, e.g. soaking pit), the maximum heat transfer takes place by__________________?
A. Conduction
B. Convection
C. Radiation
D. Cannot be predicted - The heating capacity of muffle furnace depends on the____________________?
A. Surface area & emissivity of the stock
B. Properties of the muffle wall (temperature, area, and emissivity)
C. Both A. & B.
D. Neither A. nor B. - The heating capacity of muffle furnace depends on the_________________?
A. Surface area & emissivity of the stock
B. Properties of the muffle wall (temperature, area, and emissivity)
C. Both A. & B.
D. Neither A. nor B. - Thermal efficiency of blast furnace stoves used for heating blast (air) may be about _____________ percent?
A. 20
B. 40
C. 60
D. 80 - Specific heating capacity of a furnace is expressed as_____________________?
A. Weight heated/hr
B. Weight heated/furnace volume
C. Weight heated/hr/furnace volume
D. None of these - Overall thermal efficiency of a lumpy coal fired suitably designed heating furnace, if operated & maintained properly may be about ____________ percent?
A. 10-15
B. 25-30
C. 45-50
D. 65-70 - If the flame is produced under the hearth and then sweeps up into the heating chamber, this is called a/an ______________ furnace?
A. Sidefired
B. Underfired
C. Covered
D. Recirculating
