A. Increases its calorific value
B. Decreases its calorific value
C. Does not alter its calorific value
D. Is not possible on commercial scale
Related Mcqs:
- Percentage of hydrogen in coke oven gas may be around ___________________?
A. 10
B. 25
C. 45
D. 60 - Which adsorbent is used for removing sulphur compounds (S Q, H2S, RSH etc.) removal from coke oven gas in by-products recovery plant ?
A. Silica gel
B. Diatomaceous earth
C. Basalt
D. Bog iron (i.e., moist ferric hydroxide) - Width of the coke oven towards coke side is slightly more than that on pusher side to____________________?
A. Facilitate easy discharging of coke as it swells during carbonisation
B. Facilitate uniform heating of the oven
C. Increase the output of the coke
D. None of these - Blast furnace gas compared to coke oven gas has_________________?
A. Lower ignition temperature
B. Narrower limit of inflammability
C. Higher calorific value
D. Lower theoretical flame temperature - Coke oven gas is a better fuel than blast furnace gas, because of its higher________________?
A. Calorific value, cleanliness and relatively low distribution cost (due to its low specific gravity)
B. Adiabatic flame temperature
C. Heat release rate (thus requiring smaller combustion chamber)
D. All A., B. and C. - Coke oven gas compared to blast furnace gas is________________?
A. More explosive and inflammable
B. Less poisonous
C. Lighter
D. All A., B. and C. - Coking time in beehive coke oven is about ___________________?
A. 12 hours
B. 2-3 days
C. One week
D. Two weeks - Traces of tar fog present in the coke oven gas is removed by_________________?
A. Cyclone separator
B. Wet packed scrubber
C. Electrostatic precipitator
D. Washing with monoethanolamine - Coke oven gas constitutes mainly of ____________________?
A. H2 & CO
B. H2 & CH4
C. CH4 & CO
D. H2 & CO2 - Temperature of coke oven gas just before entering into saturator (for recovery of NH3) is about ______________ °C?
A. 30
B. 65
C. 120
D. 180
