CA. Provides better control of furnace temperature
B. Facilitates combustion with lower excess air
C. Provides higher thermal efficiency & flame temperature
D. All A., B. & C.
Related Mcqs:
- Combustion of pulverised coal as compared to that of lump coal ________________?
A. Develops a non-luminous flame
B. Develops a low temperature flame
C. Can be done with less excess air
D. Provides a lower rate of heat release - In case of pulverised coal fired steam boiler, the secondary air serves the main purpose of__________________?
A. Transportation of coal
B. Drying of coal
C. Combustion of coal by supplying it around the burner
D. Preheating the primary air - Bulk density of pulverised coal may be about ______________ kg/m3?
A. 100
B. 500
C. 1000
D. 1500 - Coal is pulverised before burning in large capacity boiler furnaces mainly to____________________
A. Ensure its complete combustion
B. Facilitate easy ash removal
C. Enhance its calorific value
D. Provide trouble free operation - The main function of primary air in pulverised coal fired burner is to_________________?
A. Burn CO to CO2
B. Dry and transport the coal
C. Have proper combustion by supplying it around the burner
D. Preheat the tertiary air used for complete combustion of CO to CO2 - Which of the following will be unsuitable for dust cleaning from flue gas at 400°C from a pulverised coal fired boiler ?
A. Multicyclones
B. Bag filter
C. Wet scrubber
D. Hydrocyclones - Which of the following is the most important deterrents to an extended use of pulverised coal in boiler firing ?
A. Ash disposal problem
B. Excessive fly-ash discharge from the stack
C. High power consumption in its transportation
D. Erosion of induced draft fan blades - Temperature of preheated air used for the transportation of pulverised coal through pipes to the burner of a boiler furnace is restricted to a maximum limit of about 300° C to avoid the___________________?
A. Requirement of large volume combustion chamber
B. Risk of explosion
C. Chances of clinker formation
D. Incomplete combustion of coal - Pulverised coal used in boiler firing need not have____________________?
A. Less moisture content
B. High fusion point of its ash
C. High bulk density
D. Lower ash content - The advantage of firing pulverised coal in the furnace lies in the fact, that it____________________?
A. Permits the use of high ash content coal
B. Permits the use of low fusion point ash coal
C. Accelerates the burning rate and economises on fuel combustion
D. All A., B. and C.