A. Sulphur & phosphorous content
B. Porosity
C. Fusion point of its ash
D. Hardness & strength
Related Mcqs:
- Caking index of the coal blend used for the manufacture of metallurgical coke should be around__________________?
A. 5
B. 21
C. 40
D. 48 - Desirable “Micum Index” values of metallurgical coke are ___________________?
A. M40 > 78% and M10 < 10%
B. M40 > 4% and M10 10% and M10 98% and M10 < 2% - Volatile matter content of metallurgical coke may be around ______________ percent?
A. 1-2
B. 10-15
C. 22-26
D. 30-33 - Shatter index of metallurgical coke on 2 inches and 0.5 inch screen should be respectively around _______________ percent?
A. 80 and 97
B. 95 and 100
C. 40 and 70
D. 25 and 97 - Quantity of coke produced from metallurgical coal may be around _____________ percent?
A. 30
B. 50
C. 75
D. 95 - Higher percentage of ash in coal meant for the production of metallurgical grade coke ___________________?
A. Decreases the hardness of coke
B. Decreases the abrasion resistance of coke
C. Causes brittleness in steel
D. None of these - Narrow coke ovens as compared to wider coke ovens_________________?
A. Produce smaller coke
B. Produce stronger coke
C. Require less time of carbonisation
D. All A., B. and C. - Width of the coke oven towards coke side is slightly more than that on pusher side to____________________?
A. Facilitate easy discharging of coke as it swells during carbonisation
B. Facilitate uniform heating of the oven
C. Increase the output of the coke
D. None of these - Coke made in narrower by-product coke ovens (as compared to wider ovens) is _____________________?
A. Less reactive
B. Stronger
C. Smaller in size
D. All A., B. & C. - During coal carbonisation process, the conversion of semi-coke to coke is accompanied by an increase in the _______________ of the mass?
A. Density
B. Porosity
C. Electrical resistivity
D. None of these