The rate of change of moment of momentum represents the ______________ by the fluid?

Related Mcqs:

1. Bernoulli’s equation for fluid flow is derived following certain assumptions. Out of the assumptions listed below, which set of assumptions is used in derivation of Bernoulli’s equation? A. Fluid flow is frictionless & irrotational. B. Fluid flow is steady. C. Fluid flow is uniform & turbulent. D. Fluid is compressible. E. Fluid is incompressible ?

   A. A, C, D
   B. B, D, E
   C. A, B, E
   D. A, D, E

2. When the momentum of one fluid is used for moving another fluid, such a device is called a/an______________?

   A. Jet pump
   B. Blower
   C. Acid egg
   D. None of these

3. The pressure drop per unit length of pipe incurred by a fluid ‘X’ flowing through pipe is Δp. If another fluid ‘Y’ having both the specific gravity & density just double of that of fluid ‘X’, flows through the same pipe at the same flow rate/average velocity, then the pressure drop in this case will be__________________?

   A. Δp
   B. 2Δp
   C. Δp2
   D. Δp/2

4. Momentum correction factor used in fluid flow problems accounts for the__________________?

   A. Change in direction of flow
   B. Change in total energy
   C. Change in pressure
   D. Non uniform direction of velocities at inlet & outlet sections

5. In which type of fluid flow, the velocity of flow of fluid changes from point to point in the fluid at any instant ?

   A. Rotational
   B. Unsteady
   C. Turbulent
   D. Non-uniform

6. As per Newton’s law of viscosity, the shear stress for a given rate of angular deformation of fluid is proportional to (where, μ = fluid viscosity) ?

   A. 1/μ
   B. μ
   C. μ2
   D. 1/μ2

7. A fluid whose apparent viscosity increases with shear rate is termed as the _____________ fluid?

   A. Newtonian
   B. Viscous
   C. Dilatant
   D. Non-viscous

8. A fluid which has a linear relationship between the magnitude of applied shear-stress and the resulting rate of deformation is called a/an _____________ fluid?

   A. Newtonian
   B. Non-Newtonian
   C. Ideal
   D. Incompressible

9. The location of centre of pressure, which defines the point of application of the total pressure force on the surface, can be calculated by applying the principle of moments according to which “sum of the moment of the resultant force about an axis is equal to the sum of the components about the same axis”. The centre of pressure of a rectangular surface (of width ‘w’) immersed vertically in a static mass of fluid is at a depth of (where, y = depth of the liquid) ?

   A. 1/(y/3)
   B. 2y/3
   C. 1/(y/4)
   D. 3y/4

10. The fluid velocity varies as the square of the cylindrical pipe diameter, in case of steady state laminar flow at constant pressure drop, for ______________ fluid?

    A. Newtonian
    B. Dilatant
    C. Pseudo-plastic

    D. Non-Newtonian