A. Incompressible, frictionless, steady, along a streamline
B. Uniform, steady, incompressible, along a streamline
C. Steady, density being pressure dependent, frictionless
D. None of these
Related Mcqs:
- Bernoulli’s equation for fluid flow is derived following certain assumptions. Out of the assumptions listed below, which set of assumptions is used in derivation of Bernoulli’s equation? A. Fluid flow is frictionless & irrotational. B. Fluid flow is steady. C. Fluid flow is uniform & turbulent. D. Fluid is compressible. E. Fluid is incompressible ?
A. A, C, D
B. B, D, E
C. A, B, E
D. A, D, E - Which of the following must be followed by the flow of a fluid (real or ideal)? (I) Newton’s law of viscosity. (II) Newton’s second law of motion. (III) The continuity equation. (IV) Velocity of boundary layer must be zero relative to boundary. (V) Fluid cannot penetrate a boundary?
A. I, II, III
B. II, III, V
C. I, II, V
D. II, IV, V - The pressure drop per unit length of pipe incurred by a fluid ‘X’ flowing through pipe is Δp. If another fluid ‘Y’ having both the specific gravity & density just double of that of fluid ‘X’, flows through the same pipe at the same flow rate/average velocity, then the pressure drop in this case will be__________________?
A. Δp
B. 2Δp
C. Δp2
D. Δp/2 - In which type of fluid flow, the velocity of flow of fluid changes from point to point in the fluid at any instant ?
A. Rotational
B. Unsteady
C. Turbulent
D. Non-uniform - The equation relating friction factor to Reynold number, f-0.5 = 4 loge (NRe/√f)-0.4, is called the _____________ equation?
A. Nikuradse
B. Von-Karman
C. Blasius
D. Colebrook - Colebrook equation for friction factor in turbulent flow is given by, f-0.5 = -4 loge [(ε/D) + (1.26/NRe √F). It reduces to Nikuradse equation for a value of (ϵ/D) equal to __________________?
A. 0
B. 1
C. ∞
D. 0.5 - The continuity equation of fluid mechanics utilises the principle of conservation of _________________?
A. Momentum
B. Mass
C. Energy
D. Both B. & C. - A bed of spherical particles (specific gravity 2.5) of uniform size 1500 μm is 0.5 m in diameter and 0.5 m high. In packed bed state, the porosity may be taken as 0.4. Ergun’s equation for the above fluid-particle system (in SI units) is given below : Δ P/L = 375 × 103 VOM + 10.94 × 106 V2 OM (SI units) If water is to be used as the fluidising medium, the minimum fluidisation velocity, VOM is_________________?
A. 12 mm/s
B. 16 mm/s
C. 24 mm/s
D. 28 mm/s - Which of the fluid forces are not considered in the Reynold’s equation of flow ?
A. Viscous forces
B. Turbulent forces
C. Pressure forces
D. Compressibility forces - Which of the following fluid forces are not considered in the Navier-Stoke’s equation ?
A. Gravity forces
B. Viscous forces
C. Pressure forces
D. Turbulent forces
