A. Steady, incompressible, irrotational
B. Steady, compressible, irrotational
C. Steady, compressible and along a streamline
D. Unsteady, incompressible, irrotational
Related Mcqs:
- In case of unsteady fluid flow, conditions & flow pattern change with the passage of time at a position in a flow situation. Which of the following is an example of unsteady flow ?
A. Discharge of water by a centrifugal pump being run at a constant rpm
B. Water flow in the suction and discharge pipe of a reciprocating pump
C. Water discharge from a vertical vessel in which constant level is maintained
D. Low velocity flow of a highly viscous liquid through a hydraulically smooth pipe - Bernoulli’s equation for fluid flow is derived following certain assumptions. Out of the assumptions listed below, which set of assumptions is used in derivation of Bernoulli’s equation? A. Fluid flow is frictionless & irrotational. B. Fluid flow is steady. C. Fluid flow is uniform & turbulent. D. Fluid is compressible. E. Fluid is incompressible ?
A. A, C, D
B. B, D, E
C. A, B, E
D. A, D, E - Which of the following must be followed by the flow of a fluid (real or ideal)? (I) Newton’s law of viscosity. (II) Newton’s second law of motion. (III) The continuity equation. (IV) Velocity of boundary layer must be zero relative to boundary. (V) Fluid cannot penetrate a boundary?
A. I, II, III
B. II, III, V
C. I, II, V
D. II, IV, V - The energy loss in flow through Venturimeter is less than that through flow nozzle, because in case of a flow nozzle, the ?
A. Length is shorter
B. Throat diameter is more
C. Sudden expansion of flow in the downstream occurs
D. Distance between the throat and the inlet is more - Applying a pressure drop across a capillary results in a volumetric flow rate ‘Q’ under laminar flow conditions. The flow rate for the same pressure drop, in a capillary of the same length but half the radius is____________________?
A. Q/2
B. Q/4
C. Q/8
D. Q/16 - For flow through a venturi at a particular discharge, the correct relationships among heads at points X, Y, and Z are__________________?
A. h1 > h2 < h3
B. h1 > h2 > h3
C. h2 < h1 < h3
D. h1 < h2 < h3 - In case of Couette flow, the fluid flow is between two large flat parallel plates with___________________?
A. Top plate moving and the bottom plate fixed
B. Bottom plate moving and the top plate fixed
C. Both the plates fixed
D. Both the plates moving - Pressure difference between two points in vessels, pipelines or in two different pipelines can be measured by a differential manometer. The pressure difference measured as the mm of water column in case of mercury-water, differential manometer is equal to (where, H = difference in height of mercury column in mm)?
A. H
B. 12.6 H
C. 13.6 H
D. 14.6 H - A streamline is a line in flow field _________________?
A. That is traced by all the fluid particles passing through a given point
B. Along which a fluid particle travels
C. Such that at every point on it, the velocity is tangential to it
D. None of these - A centrifugal pump is used to pump water through a horizontal distance of 150 m, and then raised to an overhead tank 10 m above. The pipe is smooth with an I.D of 50 mm. What head (m of water) must the pump generate at its exit E. to deliver water at a flow rate of 0.001 m3/s? The Fanning friction factor, f is 0.0062 ?
A. 10 m
B. 11 m
C. 11.8 m
D. 30 m
