A. Non-steady uniform
B. Non-steady non-uniform
C. Steady uniform
D. Steady non-uniform
Related Mcqs:
- Bernoulli’s equation for fluid flow is derived following certain assumptions. Out of the assumptions listed below, which set of assumptions is used in derivation of Bernoulli’s equation? A. Fluid flow is frictionless & irrotational. B. Fluid flow is steady. C. Fluid flow is uniform & turbulent. D. Fluid is compressible. E. Fluid is incompressible ?
A. A, C, D
B. B, D, E
C. A, B, E
D. A, D, E - In which type of fluid flow, the velocity of flow of fluid changes from point to point in the fluid at any instant ?
A. Rotational
B. Unsteady
C. Turbulent
D. Non-uniform - In case of unsteady fluid flow, conditions & flow pattern change with the passage of time at a position in a flow situation. Which of the following is an example of unsteady flow ?
A. Discharge of water by a centrifugal pump being run at a constant rpm
B. Water flow in the suction and discharge pipe of a reciprocating pump
C. Water discharge from a vertical vessel in which constant level is maintained
D. Low velocity flow of a highly viscous liquid through a hydraulically smooth pipe - Gradually varied flow in open channel is a/an ____________ flow?
A. Steady uniform
B. Steady non-uniform
C. Unsteady uniform
D. Unsteady non-uniform - The pressure drop per unit length of pipe incurred by a fluid ‘X’ flowing through pipe is Δp. If another fluid ‘Y’ having both the specific gravity & density just double of that of fluid ‘X’, flows through the same pipe at the same flow rate/average velocity, then the pressure drop in this case will be__________________?
A. Δp
B. 2Δp
C. Δp2
D. Δp/2 - The fluid velocity varies as the cube of the cylindrical pipe diameter in case of steady state laminar flow at constant pressure drop for ____________ fluid?
A. Newtonian
B. Pseudo-plastic
C. Dilatent
D. Bingham plastic - ____________ flow means the flow of incompressible fluid with no shear ?
A. Potential
B. Streamline
C. Creep
D. Boundary layer - The fluid velocity varies as the square root of the cylindrical pipe diameter in case of steady state laminar flow at constant pressure drop of _____________ fluid?
A. Dilatent
B. Pseudo-plastic
C. Bingham plastic
D. Newtonian - Which of the following must be followed by the flow of a fluid (real or ideal)? (I) Newton’s law of viscosity. (II) Newton’s second law of motion. (III) The continuity equation. (IV) Velocity of boundary layer must be zero relative to boundary. (V) Fluid cannot penetrate a boundary?
A. I, II, III
B. II, III, V
C. I, II, V
D. II, IV, V - The ratio of average fluid velocity to the maximum velocity in case of laminar flow of a Newtonian fluid in a circular pipe is_____________________?
A. 0.5
B. 1
C. 2
D. 0.66
