A. V1 < V2 < V3
B. V2 > V1 and V2 > V3
C. V1 > V2 > V3
D. None of these
Related Mcqs:
- For flow through a venturi at a particular discharge, the correct relationships among heads at points X, Y, and Z are__________________?
A. h1 > h2 < h3
B. h1 > h2 > h3
C. h2 < h1 < h3
D. h1 < h2 < h3 - Co-efficient of discharge (Cd) is defined as actual discharge/theoretical discharge and is equal to Cc . Cv; where Cc = Co-efficient of contraction and Cv = co-efficient of velocity. Cd of an orifice is usually about__________________?
A. 0.42
B. 0.62
C. 0.82
D. 0.98 - In case of unsteady fluid flow, conditions & flow pattern change with the passage of time at a position in a flow situation. Which of the following is an example of unsteady flow ?
A. Discharge of water by a centrifugal pump being run at a constant rpm
B. Water flow in the suction and discharge pipe of a reciprocating pump
C. Water discharge from a vertical vessel in which constant level is maintained
D. Low velocity flow of a highly viscous liquid through a hydraulically smooth pipe - Bernoulli’s equation for fluid flow is derived following certain assumptions. Out of the assumptions listed below, which set of assumptions is used in derivation of Bernoulli’s equation? A. Fluid flow is frictionless & irrotational. B. Fluid flow is steady. C. Fluid flow is uniform & turbulent. D. Fluid is compressible. E. Fluid is incompressible ?
A. A, C, D
B. B, D, E
C. A, B, E
D. A, D, E - The ratio of the depth of flow to the diameter of the channel for maximum discharge in a circular channel in open channel flow is________________?
A. 0.1
B. 0.55
C. 0.95
D. 1.85 - Permanent pressure loss in a well designed Venturimeter is about _____________ percent of the venturi differential?
A. 1
B. 10
C. 30
D. 50 - The percentage slip in a reciprocating pump set is given by the % of (where, Q1 = actual discharge Q2 = theoretical discharge) ?
A. Q1/Q2
B. Q2/Q1
C. (Q2 – Q1)/Q1
D. (Q2 – Q1)/Q2 - The ratio of actual discharge to theoretical discharge through an orifice is equal to______________?
A. Cc . Cv
B. Cc . Cd
C. Cv . Cd
D. Cd/Cv - Umf is the minimum fluidisation velocity for a bed of particles. An increase in the superficial gas velocity from 2 Umf to 2.5 Umf results in (all velocities are smaller than the entrainment velocity of the particles) no change in the_______________?
A. Drag on particles
B. Drag on column walls
C. Bed height
D. Bed voidage - Consider a centrifugal pump having a specific impeller diameter, fixed impeller speed pumping a liquid of constant density at a particular discharge capacity. With decrease in the capacity of the pump, the _______________ decreases?
A. NPSH required
B. BHP required by the pump
C. Head of the liquid pumped
D. All A., B. and C.
