______________ is an example of axial flow impeller?

Related Mcqs:

1. The blades of a centrifugal impeller are said to be curved forward, if the ____________ of the motion of impeller blades?

   A. Inlet tip of a blade curves in a direction opposite to that
   B. Outlet tip of a blade curves in a direction opposite to that
   C. Inlet tip of a blade is towards the direction
   D. Outlet tip of a blade is towards the direction

2. Consider a centrifugal pump having a specific impeller diameter, fixed impeller speed pumping a liquid of constant density at a particular discharge capacity. With decrease in the capacity of the pump, the _______________ decreases?

   A. NPSH required
   B. BHP required by the pump
   C. Head of the liquid pumped
   D. All A., B. and C.

3. ______________ pumps are axial flow pumps?

   A. Turbine
   B. Propeller
   C. Diffuser
   D. None of these

4. In case of unsteady fluid flow, conditions & flow pattern change with the passage of time at a position in a flow situation. Which of the following is an example of unsteady flow ?

   A. Discharge of water by a centrifugal pump being run at a constant rpm
   B. Water flow in the suction and discharge pipe of a reciprocating pump
   C. Water discharge from a vertical vessel in which constant level is maintained
   D. Low velocity flow of a highly viscous liquid through a hydraulically smooth pipe

5. Bernoulli’s equation for fluid flow is derived following certain assumptions. Out of the assumptions listed below, which set of assumptions is used in derivation of Bernoulli’s equation? A. Fluid flow is frictionless & irrotational. B. Fluid flow is steady. C. Fluid flow is uniform & turbulent. D. Fluid is compressible. E. Fluid is incompressible ?

   A. A, C, D
   B. B, D, E
   C. A, B, E
   D. A, D, E

6. While starting an axial flow pump, its delivery valve should be kept _______________?

   A. Open
   B. Closed
   C. Either open or closed
   D. None of these

7. A pipe has a porous section of length L as shown in the figure. Velocity at the start of this section of V0. If fluid leaks into the pipe through the porous section at a volumetric rate per unit area q(x/L)2, what will be axial velocity in the pipe at any „x‟? Assume incompressible one dimensional flow i.e., no gradients in the radial direction ?

   A. VX = V0 + q (x3/L2D)
   B. VX = V0 + ⅓q (x3/L2)
   C. VX = V0 + 2q (x2/LD)
   D. VX = V0 + (4/3) q (x3/L2D)

8. The energy loss in flow through Venturimeter is less than that through flow nozzle, because in case of a flow nozzle, the ?

   A. Length is shorter
   B. Throat diameter is more
   C. Sudden expansion of flow in the downstream occurs
   D. Distance between the throat and the inlet is more

9. Applying a pressure drop across a capillary results in a volumetric flow rate ‘Q’ under laminar flow conditions. The flow rate for the same pressure drop, in a capillary of the same length but half the radius is____________________?

   A. Q/2
   B. Q/4
   C. Q/8
   D. Q/16

10. In case of a centrifugal pump, the ratio of total delivered pressure to pressure developed with the impeller is called the _____________ efficiency?

    A. Manometric
    B. Mechanical
    C. Volumetric
    D. Overall