A. Corrosive in nature
B. Toxic and harmful to some crops
C. Helpful in decomposition of urea
D. Explosive in nature
Related Mcqs:
- Prilling of urea should be accomplished (in a sprayer) just above the melting point of urea with minimum of retention time, otherwise it will result in__________________?
A. Low bulk density product
B. Biuret formation
C. Non-spherical prills
D. Substantially wet non-flowing and sticky product - Chemical formula of biuret is_________________?
A. NH2.CO.NH2
B. NH3.COO.NH3
C. NH2CONHCONH2
D. NH4COONH2 - Nitrogen content of urea is about _____________ percent ?
A. 10
B. 46
C. 80
D. 94 - Urea is a better fertilizer than ammonium sulphate, because__________________?
A. It is cheaper
B. Nitrogen content is higher
C. It is not poisonous
D. It is easy to manufacture - Lower temperature and large excess of ammonia in urea melt__________________?
A. Increases biuret formation
B. Decreases biuret formation
C. Is undesirable
D. Does not effect biuret formation - The composition of fresh feed to the high temperature, high pressure urea autoclave is______________________?
A. Excess liquid ammonia and liquefied CO2
B. Excess liquid ammonia and compressed CO2 gas
C. Liquid ammonia and excess compressed CO2
D. Compressed ammonia gas and excess compressed CO2 - Raw materials for urea production are _________________?
A. CO2 and N2
B. CO2, H2 and N2
C. NH3 and CO
D. HNO3 and CaCO3 - Temperature and pressure in urea autoclave is_________________?
A. 120°C and 300 atm
B. 190°C and 200 atm
C. 400°C and 550 atm
D. 200°C and 10 atm - In the manufacture of urea, the intermediate chemical formed is__________________?
A. Biuret
B. Ammonium carbamate
C. Ammonium carbonate
D. None of these - Dehydration of ammonium carbamate to yield urea is a/an __________________ reaction?
A. Exothermic
B. Endothermic
C. Autocatalytic
D. Catalytic
