A. Magnesite
B. Chrome
C. Silica
D. Fireclay
Related Mcqs:
- A furnace is made of a refractory brick wall of thickness 0.5 metre and thermal conductivity 0.7 W/m.°K For the same temperature drop and heat loss, this refractory wall can be replaced by a layer of diatomaceous earth of thermal conductivity 0.14 W/m.K and thickness ______________ metre?
A. 0.01
B. 0.1
C. 0.25
D. 0.5 - Minimum temperature upto which water can be theoretically cooled down in the cooling tower by evaporative cooling is equal to the ______________ temperature of air?
A. Wet bulb
B. Dry bulb
C. Saturation
D. Dew point - The heat released by cooling one mole of copper from 400 K to room temperature (300 K) is (assume : Cp of copper is 23 J K-1mole-1) ?
A. 2300 J
B. 4600 J
C. 230 J
D. 2.3 × 106 J - Temperature of hot gases flowing in a pipe is measured by a thermocouple inserted in the thermal well. The thermal well made of ______________ will facilitate the most accurate measurement of the temperature ?
A. Copper
B. Steel
C. Aluminium
D. Brass - The boiling & freezing points on a newly defined temperature scale in degree ‘D’ are 400°D & 100°D respectively. The temperature reading corresponding to 60°C on this new temperature scale will be equal to _____________ °D ?
A. 140
B. 180
C. 240
D. 280 - Heating the Hypo-eutectoid steels to 30°C above the upper critical temperature line, soaking at that temperature and then cooling slowly to the room temperature to form a pearlite & ferrite structure is called_______________________?
A. Tempering
B. Hardening
C. Annealing
D. Normalising - The ratio of thermal & electrical conductivity is same for all the metals at the same temperature; and at around room temperature, this ratio is proportional to(where, T = absolute temperature, °K) ?
A. T
B. 1/T
C. T2
D. 1/T2 - Principal alloying elements of cast tool alloys which have very high wear resistance & high temperature strength are ?
A. Cobalt, chromium & tungsten
B. Cobalt, chromium & nickel
C. Molybdenum, tungsten & chromium
D. Cobalt, zirconium & molybdenum - _______________ is the hardest oxide and is hence used where high wear resistance at high temperature is required?
A. Beryllium
B. Zirconia
C. Alumina
D. Magnesia - Evaporative cooling process employs a combination of cooling and humidification in which the____________________?
A. Sensible heat is added
B. Sensible heat is removed and the latent heat is added
C. Latent heat is removed
D. Sensible heat is added and latent heat is removed
Mcq Added by: admin