A. Chromel-alumel
B. Copper-constantan
C. Platinum-platinum rhodium
D. Iron-constantan
Related Mcqs:
- Temperature of hot gases flowing in a pipe is measured by a thermocouple inserted in the thermal well. The thermal well made of ______________ will facilitate the most accurate measurement of the temperature ?
A. Copper
B. Steel
C. Aluminium
D. Brass - Minimum temperature upto which water can be theoretically cooled down in the cooling tower by evaporative cooling is equal to the ______________ temperature of air?
A. Wet bulb
B. Dry bulb
C. Saturation
D. Dew point - High speed steel tools retain their hardness upto a temperature of __________________ °C?
A. 500
B. 750
C. 900
D. 1100 - _____________ is the process of coating the surface of steel with aluminium oxide, thereby imparting it increased resistance to corrosion & oxidation upto a temperature of 700°C ?
A. Veneering
B. Galvanising
C. Electroplating
D. Calorising - The boiling & freezing points on a newly defined temperature scale in degree ‘D’ are 400°D & 100°D respectively. The temperature reading corresponding to 60°C on this new temperature scale will be equal to _____________ °D ?
A. 140
B. 180
C. 240
D. 280 - Heating the Hypo-eutectoid steels to 30°C above the upper critical temperature line, soaking at that temperature and then cooling slowly to the room temperature to form a pearlite & ferrite structure is called_______________________?
A. Tempering
B. Hardening
C. Annealing
D. Normalising - The ratio of thermal & electrical conductivity is same for all the metals at the same temperature; and at around room temperature, this ratio is proportional to(where, T = absolute temperature, °K) ?
A. T
B. 1/T
C. T2
D. 1/T2 - _____________ glass is used in the mercury in glass thermometer meant for measuring a temperature of 500°C ?
A. Borosilicate
B. High silica
C. Supermax
D. Lead - A thin, flat & square plate measuring 2 m × 2 m is freely hanging in ambient air at 25°C. It is exposed to the solar radiation falling on one side of the plate at the rate of 500 W/m2. The plate temperature will remain constant at 30°C, if the convective heat transfer co-efficient is ________________ W/m2 °C ?
A. 50
B. 100
C. 150
D. 200 - Upto the critical radius of insulation, added insulation, will____________________?
A. Increase the heat loss
B. Decrease heat loss and will have no effect beyond that
C. Decrease heat flux
D. Reduce convection heat loss compared to conduction heat less
