Recrystallisation temperature of steel is ______________________ °C?

Related Mcqs:

1. While the recrystallisation temperature for pure metals is 0.3 Tm, the same for alloys is equal to ______________ × Tm (where, Tm Melting temperature) ?

   A. 0.25
   B. 0.45
   C. 0.70
   D. 0.95

2. Other parameters remaining same, the recrystallisation temperature of an alloy is lowered, when_________________?

   A. Strain rate is increased
   B. Grain size is increased
   C. Prior cold deformation is increased
   D. Not affected by any of the above parameters

3. The ‘transition temperature’ for ductile to brittle behavior of steel increases with increase in the _____________ content in steel?

   A. Carbon
   B. Manganese
   C. Both A nor B
   D. Neither A nor B

4. The boiling & freezing points on a newly defined temperature scale in degree ‘D’ are 400°D & 100°D respectively. The temperature reading corresponding to 60°C on this new temperature scale will be equal to _____________ °D ?

   A. 140
   B. 180
   C. 240
   D. 280

5. Heating the Hypo-eutectoid steels to 30°C above the upper critical temperature line, soaking at that temperature and then cooling slowly to the room temperature to form a pearlite & ferrite structure is called_______________________?

   A. Tempering
   B. Hardening
   C. Annealing
   D. Normalising

6. The ratio of thermal & electrical conductivity is same for all the metals at the same temperature; and at around room temperature, this ratio is proportional to(where, T = absolute temperature, °K) ?

   A. T
   B. 1/T
   C. T2
   D. 1/T2

7. Coating thickness in case of galvanising of steel sheet generally corresponds to the deposition of _______________ gms of zinc per m2 of steel strip ?

   A. 5-10
   B. 1000-1500
   C. 120-500
   D. 1500-3000

8. Square steel key is normally strong in failure by shear & crushing. Keys are normally made of _______________ steel bars?

   A. Hot rolled mild
   B. Cold rolled mild
   C. Forged
   D. Machinable stainless

9. Steel containing low percentage of nickel, chromium & tungsten are termed as the _____________ steel ?

   A. Wrought
   B. Tool
   C. Alloy
   D. Plain carbon

10. Steel rods are normally used for concrete reinforcement because concrete and steel have almost equal_________________?

    A. Tensile strength
    B. Compressive strength
    C. Young’s modulus
    D. Thermal co-efficient of expansion