A. Forward curved
B. Backward curved
C. Double curved
D. Radial or straight
Related Mcqs:
- Elimination of brittleness resulting from welding of saw blades is done by __________________ of the welded portion ?
A. Annealing
B. Toughening
C. Work hardening
D. Tempering - Thermodynamic cycle involved in the working of a thermal power plant is the ______________ cycle ?
A. Joule
B. Carnot
C. Rankine
D. Brayton - The most prominent single cause of corrosion in boiler-tubes, drums, economisers and steam superheaters in a thermal power plant boiler is the_______________?
A. Water alkalinity & leakage
B. Hydrazine addition during feed water treatment
C. Release of non-condensable gas from water in the boiler
D. Scale formation - Work hardenable alloy steel used to make the bucket wheel excavators, blades of bulldozers and other earth moving equipments contain iron, carbon and ___________________?
A. Manganese
B. Silicon
C. Nickel
D. Chromium - Which of the following parameters is not responsible for the heat loss from a hot steam carrying bare pipe surface located in a room without fans ?
A. Emissivity of pipe surface
B. Diameter & length of the pipe
C. Temperature of hot pipe surface & that of air in the room
D. None of these - Temperature of hot gases flowing in a pipe is measured by a thermocouple inserted in the thermal well. The thermal well made of ______________ will facilitate the most accurate measurement of the temperature ?
A. Copper
B. Steel
C. Aluminium
D. Brass - Thermal diffusivity of a substance is proportional to (where, k = Thermal conductivity) ____________________?
A. 1/k
B. k
C. k2
D. 1/k2 - A furnace is made of a refractory brick wall of thickness 0.5 metre and thermal conductivity 0.7 W/m.°K For the same temperature drop and heat loss, this refractory wall can be replaced by a layer of diatomaceous earth of thermal conductivity 0.14 W/m.K and thickness ______________ metre?
A. 0.01
B. 0.1
C. 0.25
D. 0.5 - Which of the following is used to produce draught in the locomotive boilers ?
A. Chimney
B. Induced draught fan
C. Forced draught fan
D. Steam jet arrangement - Thermal equivalent of electrical power in practical calculation is _______________ kcal/kWh ?
A. 746
B. 3000
C. 1000
D. 550
