A. Less
B. More
C. Same
D. Either more or less; depends upon the solvent
Related Mcqs:
- The vapor pressure of the solvent decreased by 10 mm Hg, when a non-volatile solute was added to the solvent. The mole fraction of the solute in the solution is 0.2. What should be the mole fraction of the solvent, if the decrease in vapor pressure of the solvent is required to be 20 mm Hg ?
A. 0.2
B. 0.1
C. 0.4
D. 0.6 - The vapour pressure of a solution (made by dissolving a solute in a solvent) is ____________ that of the pure solvent?
A. Less than
B. More than
C. Equal to
D. Either more or less; depends on the solvent - A solution is made by dissolving 1 kilo mole of solute in 2000 kg of solvent. The molality of the solution is_________________?
A. 2
B. 1
C. 0.5
D. 0.05 - The elevation in boiling point of a solution is proportional to the ______________ of the solution?
A. Molal concentration
B. Reciprocal of the molal concentration
C. Normality
D. Molarity - 80 kg of Na2SO4 (molecular weight = 142) is present in 330 kg of an aqueous solution. The solution is cooled such that. 80 kg of Na2SO4 .10H2O crystals separate out. The weight fraction of Na2SO4 in the remaining solution is_________________?
A. 0.00
B. 0.18
C. 0.24
D. 1.00 - Addition of a non-volatile solute to a solvent produces a ______________ in its solvent?
A. Freezing point elevation
B. Boiling point depression
C. Vapor pressure lowering
D. All A., B. & C. - If the partial pressure of the solvent in the vapor phase is equal to the vapor pressure of the solvent at that temperature, then the system is said to be at its___________________?
A. Bubble point
B. Saturation temperature
C. Dew point
D. Both B. and C. - Under conditions of equal reduced pressure and equal reduced temperature, substances are said to be in the ‘corresponding states’. At equal reduced conditions i.e., at the corresponding state, the ____________ of different gases are nearly the same?
A. Compressibility
B. Molecular weight
C. Humidity
D. None of these - Even though heat transfer co-efficient in boiling liquids is large, use of fins is advantageous, when the entire surface is exposed to ________________ boiling ?
A. Film
B. Nucleate
C. Transition
D. All modes of - Trouton’s ratio is given by (where λb, = molal heat of vaporisation of a substance at its normal boiling point, kcal/kmol Tb = normal boiling point, °K) ___________________?
A. λb/Tb
B. Tb/λb
C. √(λb/Tb)
D. √(Tb/λb)