A long cylinder and a sphere both of 5 cms diameter are made from the same porous material. The flat ends of cylinder are sealed. Both the cylinder and sphere are saturated with the same solution of sodium chloride. Later both the objects are immersed for a short and equal interval of time in a large tank of water which is well agitated. The fraction of salt remaining in the cylinder and the sphere are Xc and Xs respectively. Which of the following statement is correct ?

Related Mcqs:

1. The boiling points for pure water and pure toluene are 100°C and 110.6°C respectively. Toluene and water are completely immiscible in each other. A well agitated equimolar mixture of toluene and water are prepared. The temperature at which the above mixture will exert a pressure of one standard atm. is___________________?

   A. Less than 100°C
   B. 100°C
   C. Between 100 and 110°C
   D. 110.6°C

2. Saturated solution of benzene in water is in equilibrium with a mixture of air and vapours of benzene and water at room temperature and pressure. Mole fraction of benzene in liquid is xB and the vapour pressures of benzene and water at these conditions are pv B and pv w respectively. The partial pressure of benzene in air-vapour mixture is_________________?

   A. PvB
   B. xB.PvB
   C. (Patm – Pvw)xB
   D. xB.Patm

3. A solid metallic block weighing 5 kg has an initial temperature of 500°C. 40 kg of water initially at 25°C is contained in a perfectly insulated tank. The metallic block is brought into contact with water. Both of them come to equilibrium. Specific heat of block material is 0.4 kJ.kg-1. K-1. Ignoring the effect of expansion and contraction and also the heat capacity to tank, the total entropy change in kJ.kg-1, K-1 is_________________?

   A. -1.87
   B. 0
   C. 1.26
   D. 3.91

4. 80 kg of Na2SO4 (molecular weight = 142) is present in 330 kg of an aqueous solution. The solution is cooled such that. 80 kg of Na2SO4 .10H2O crystals separate out. The weight fraction of Na2SO4 in the remaining solution is_________________?

   A. 0.00
   B. 0.18
   C. 0.24
   D. 1.00

5. The vapor pressure of the solvent decreased by 10 mm Hg, when a non-volatile solute was added to the solvent. The mole fraction of the solute in the solution is 0.2. What should be the mole fraction of the solvent, if the decrease in vapor pressure of the solvent is required to be 20 mm Hg ?

   A. 0.2
   B. 0.1
   C. 0.4
   D. 0.6

6. The weight fraction of methanol in an aqueous solution is 0.64. The mole fraction of methanol XM satisfies________________?

   A. XM < 0.5
   B. XM = 0.5
   C. 0.5 < XM < 0.64
   D. XM ≥ 0.64

7. Dryness fraction of wet steam is defined as the ratio of mass of vapour in the mixture to the mass of mixture ______________ calorimeter is not used for measuring the dryness fraction of steam?

   A. Bomb
   B. Separating
   C. Bucket
   D. Throttling

8. The vapor pressures of benzene and toluene are 3 and 4/3 atmospheres respectively. A liquid feed of 0.4 moles of benzene and 0.6 moles of toluene is vaporised. Assuming that the products are in equilibrium, the vapor phase mole fraction of benzene is_________________?

   A. 0.4
   B. 0.6
   C. 0.8
   D. 0.2

9. Vapor pressure of a solution is proportional to (where, Sv and St are mole fraction of solvent and solute respectively) ?

   A. Sv
   B. 1/St
   C. St
   D. 1/Sv

10. Assume that benzene is insoluble in water. The normal boiling points of benzene and water are 80.1 and 100°C respectively. At a pressure of 1 atm, the boiling point of a mixture of benzene and water is__________________?

    A. 80.1°C
    B. Less than 80.1°C
    C. 100°C
    D. Greater than 80.1°C but less than 100°C