A. irrelevant range
B. relevant range
C. significant range
D. insignificant range
Related Mcqs:
- In the ‘specification analysis’, the assumptions related to residuals states must be __________?
A. worst
B. independent
C. dependent
D. good - Bernoulli’s equation for fluid flow is derived following certain assumptions. Out of the assumptions listed below, which set of assumptions is used in derivation of Bernoulli’s equation? A. Fluid flow is frictionless & irrotational. B. Fluid flow is steady. C. Fluid flow is uniform & turbulent. D. Fluid is compressible. E. Fluid is incompressible ?
A. A, C, D
B. B, D, E
C. A, B, E
D. A, D, E - In the specification analysis, the assumptions related to variance state that: ________________?
A. variance of residuals is constant
B. variance of goodness is constant
C. goodness of fit is constant
D. standard error is constant - An assumption of specification analysis, which states all the values of residuals which are uniformly scattered around regression line is classified as __________?
A. abnormality of residuals
B. normality of regression
C. normality of residuals
D. abnormality of regression - An assumption of specification analysis states: any observation does not belong to any other observation’s residual value, is classified as ___________?
A. independence of residuals
B. dependence of residuals
C. independence of correlation
D. none of the above - Which of the following is the non-linearity caused by servomotor ?
A. Static friction
B. Backlash
C. Saturation
D. None of the above - The particular communication that must be achieve within definite target audience within specific time is classified as?
A. message decision
B. media decision
C. advertising objective
D. advertising evaluation - All the conditions or assumptions of regression analysis in simple regression can give __________?
A. dependent estimation
B. independent estimation
C. reliable estimates
D. unreliable estimates - In Regression Analysis, the testing of assumptions if these are true or not is classified as ___________?
A. weighted analysis
B. average analysis
C. significance analysis
D. specification analysis - In assumptions of specific analysis, the normality of residuals is satisfied with the use of __________?
A. real price data
B. real cost data
C. multiplier data
D. divisional data
Mcq Added by: Lubaba Zarshal