A. Under damped
B. Critically damped
C. Over damped
D. None of the above
Related Mcqs:
- Water is flowing through a series of four tanks and getting heated as shown in figure. It is desired to design a cascade control scheme for controlling the temperature of water leaving the tank 4 as there is a disturbance in the temperature of a second stream entering the tank 2. Select the best place to take the secondary measurement for the second loop?
A. Tank 1
B. Tank 2
C. Tank 3
D. Tank 4 - Response of a system to a sinusoidal input is called _____________ response?
A. Impulse
B. Unit step
C. Frequency
D. None of these - Response of a linear control system for a change in set point is called __________________?
A. Frequency response
B. Transient response
C. Servo problem
D. Regulator problem - Platinum resistance thermometer is the international standard for temperature measurement between __________________?
A. Triple point of hydrogen and freezing point of antimony
B. 13.81°K to 903.9°K
C. Both A. and B.
D. Neither A. nor B. - Bode diagram are generated from output response of the system subjected to which of the following input ?
A. Impulse
B. Step
C. Ramp
D. Sinusoidal - The frequency response of a dynamic element shows a constant magnitude ratio at all frequencies. The element exhibits a negative phase shift at all frequencies. The absolute value of the phase shift increases linearly with frequency. The element has the transfer function ?
A. e-ηS
B. (T1S + 1)/(T2S + 1)
C. (T1S/(T2S + 1)
D. (T1S + 1)/(T2S - For increased speed of response of an expansion pressure spring thermometer, the thermometer bulb should have a__________________?
A. Large area but small mass
B. High thermal conductivity
C. Small specific heat
D. All A , B & C - Phase lag of the frequency response of a second order system to a sinusoidal forcing function______________?
A. Is 30°
B. Is 90° at the most
C. Approaches 180° asymptotically
D. Is 120° - Thermal well made of _____________ gives the fastest speed of response, while measuring temperature by thermocouples?
A. Steel
B. Vycor (a glass)
C. Nichrome
D. Inconel - A first order system with a time constant of 1 min is subjected to frequency response analysis. At an input frequency of 1 radian/min, the phase shift is______________?
A. 45°
B. -90°
C. -180°
D. -45°