A. Large scale evaporation of liquor is needed
B. Corrosive liquids are to be concentrated
C. Fuel is cheaply available
D. Evaporation on small scale is to be done
Related Mcqs:
- Multiple effect evaporation accounts for___________________?
A. Steam economy
B. Lower operating costs
C. Investment economy
D. None of these - For evaporation of viscous solution in a multiple effect evaporator, the preferred feeding scheme is _________________?
A. Forward
B. Backward
C. Parallel
D. None of these - A multiple effect evaporator as compared to a single effect evaporator of the same capacity has _________________?
A. Lower heat transfer area
B. Lower steam economy
C. Higher steam economy
D. Higher solute concentration in the product - In a multiple effect evaporator, the effect of boiling point elevation is to______________________?
A. Reduce the capacity
B. Reduce the economy
C. Increase the economy
D. None of these - Evaporation of 1kg of water from a solution in a single effect evaporator requires about ________________ kg of steam?
A. 0.4 – 0.6
B. 1-1.3
C. 1.8-2
D. 2 – 2.4 - A dilute aqueous solution is to be concentrated in an evaporator system. High pressure steam is available. Multiple effect evaporator system is employed, because__________________?
A. Total heat transfer area of all the effects is -less than that in a single effect evaporator system
B. Total amount of vapor produced per Kg of feed steam in a multiple effect system is much
higher than in a single effect
C. Boiling point elevation in a single effect system is much higher than that in any effect in a
multi-effect system
D. Heat transfer co-efficient in a single effect is much lower than that in any effect in a multieffect
system - In a forward feed multiple effect, the pressure build up will be____________________?
A. Least at the inlet of the first effect
B. Least at the outlet of the last effect
C. Highest at the inlet of the last effect
D. Highest at the outlet of the last effect - The advantage of backward feed multiple effect evaporators over forward feed units is that___________________?
A. Heat sensitive material can be handled
B. There is no additional cost of pumping
C. Most concentrated liquid is at highest temperature
D. Equal heat transfer co-efficients exist in various effects - In a backward feed multiple effect evaporator ___________________ ?
A. Feed is introduced in the first effect
B. Feed flows from low pressure to high pressure
C. No pumps are required between successive effects
D. None of these - A backward feed multiple effect evaporator is better than forward feed for concentrating cold feed, because it provides __________________?
A. Higher economy
B. Lower capacity
C. Both A. & B.
D. Lower economy