A. Single stirred tank (v = 5 litres)
B. Two stirred tank (each of 2.5 litres) in series
C. Stirred tank followed by tubular flow reactor (each of 2.5 litres)
D. Single tubular flow reactor (v = 5 litres)
Related Mcqs:
- Which of the following will give maximum gas conversion ?
A. Fixed bed reactor
B. Fluidised bed reactor
C. Semi-fluidised bed reactor
D. Plug-flow catalytic reactor - The conversion XA and residence time data are collected for zero order liquid phase reaction in a stirred tank reactor. Which of the following will be a straight line ?
A. XA Vs . η
B. XA Vs ln η
C. XA/(1 – XA)Vs η
D. XA(1 – XA)Vs η - An isothermal aqueous phase reversible reaction, P ⇌ R, is to be carried out in a mixed flow reactor. The reaction rate in k.mole/m3 .h is given by, r = 0.5CP – 0.125CR. A stream containing only P enters the reactor. The residence time required (in hours) for 40% conversion of P is_________________?
A. 0.80
B. 1.33
C. 1.60
D. 2.67 - The fractional volume change between no conversion and complete conversion, for the isothermal gas phase reaction, 2A → R, is___________________?
A. 0.5
B. -0.5
C. 1
D. 1.5 - The conversion for a first order liquid phase reaction. A → B in a CSTR is 50%. If another CSTR of the same volume is connected in series, then the % conversion at the exit of the second reactor will be_____________________?
A. 60
B. 75
C. 90
D. 100 - A liquid phase reaction is to be carried out under isothermal conditions. The reaction rate as a function of conversion has been determined experimentally and is shown in the figure given below. What choice of reactor or combination of reactors will require the minimum overall reactor volume, if a conversion of 0.9 is desired ?
A. CSTR followed by a PFR
B. PFR followed by a CSTR
C. CSTR followed by a PFR followed by a CSTR
D. PFR followed by a CSTR followed by a PFR - For the liquid phase zero order irreversible reaction A → B, the conversion of A in a CSTR is found to be 0.3 at a space velocity of 0.1min-1. What will be the conversion for a PFR with a space velocity of 0.2 min-1? Assume that all the other operating conditions are the same for CSTR and PFR ?
A. 0.15
B. 0.30
C. 0.60
D. 0.90 - For an isothermal second order aqueous phase reaction, A → B, the ratio of the time required for 90% conversion to the time required for 45% conversion is____________________?
A. 2
B. 4
C. 11
D. 22 - The fractional volume change of the system for the isothermal gas phase reaction, A → 3B, between no conversion and complete conversion is___________________?
A. 0.5
B. 1
C. 2
D. 3 - Fractional conversion _________________ for an exothermic reversible chemical reaction, when the temperature is maximum?
A. Increases
B. Remains unchanged
C. Decreases
D. Unpredictable from the data
