A. Hanger
B. Check plates
C. Toggles
D. Pitman
Related Mcqs:
- Which of the following crushers can be considered as a combination of a jaw crusher and a roller crusher ?
A. Rod mill
B. Fluid energy mill
C. Gyratory crusher
D. Ball mill - The capacity of a gyratory crusher is ______________ that of a jaw crusher with the same gape, handling the same feed & for the same product size range.?
A. Same as
B. 2.5 times
C. 5 times
D. 10 times - According to Taggart’s rule for selecting between a gyratory crusher and a jaw crusher; the later should be used, if the hourly tonnage to be crushed divided by the square of the gape expressed in cm is less than_______________?
A. 0.00184
B. 0.0184
C. 0.184
D. 1.84 - Which of the following parts of a jaw crusher is subjected to maximum wear and tear during its operation ?
A. Check plates
B. Jaw plates
C. Toggles
D. Crush shaft - Capacity (in tons/hr) of jaw/gyratory crusher is equal to (where, L = length of the receiving opening, cm S = greater width of the discharge opening, cm) ?
A. 0.01 L.S
B. 0.087 L.S
C. L.S
D. L.S/0.087 - During size reduction by a jaw crusher, the energy consumed decreases with the__________________?
A. Decreasing size of product at constant size of feed
B. Decreasing machine capacity
C. Increasing size of feed at constant reduction ratio
D. None of these - Choke crushing (in case of a Jaw crusher) compared to free crushing__________________?
A. Results in increased capacity
B. Consumes less power
C. Consumes more power
D. Both A. and C. - Which of the following is a fine crusher ?
A. Blake jaw crusher
B. Gyratory crusher
C. Toothed roll crusher
D. Dodge jaw crusher - Which of the following comes in the category of primary crusher for hard and tough stone ?
A. Jaw crusher
B. Cone crusher
C. Gyratory crusher
D. None of these - Which of the following is a coarse crusher ?
A. Smooth roll crusher
B. Toothed roll crusher
C. Gyratory crusher
D. Tube mill
