In a size reduction crushing operation, feed size is 100 to 300 mm. while the product size is 10 to 50 mm. This is a case of the _____________ crushing?

Related Mcqs:

1. In a size reduction crushing operation, feed size is 300 to 1500 mm while the product size is 100 to 300 mm. This is a case of the ________________ crushing?

   A. Secondary
   B. Fine
   C. Primary
   D. Ultrafine

2. In a size reduction crushing operation, the feed size is 10 to 50 mm, while the product size is 2 to 10 mm. This is a case of _______________ crushing?

   A. Primary
   B. Secondary
   C. Fine
   D. Ultrafine

3. What is the reduction ratio in a fine crushing operation having following feed and product sizes ?

   A. 0.5
   B. 2
   C. 5
   D. 10

4. General crushing equation is given by d(P/m) = -K (dD̅ S/D̅ n S). Bond’s crushing law is obtained by solving this equation for n = _____________ and feed of infinite size?

   A. 1
   B. 1.5
   C. 2
   D. 2.5

5. Which of the following equations is Rittinger’s crushing law? (Where P = power required by the machine, m = feed rate, k = a constant, D̅ sa & D̅ sb = volume surface mean diameter of feed & product respectively) ?

   A. P/m = K/ √Dp
   B. P/m = K . ln D̅ sa/D̅ sb
   C. P/m = K . (1/ D̅ sb – 1/D̅ sa)
   D. None of these

6. According to Bond crushing law, the work required to form particle of size ‘D’ from very large feed is (where (S/V)p and (S/V)f are surface to volume ratio of the product and feed respectively) ?

   A. (S/V)p
   B. √(S/V)p
   C. (S/V)2p
   D. (S/V)f

7. What is the usual value of angle of nip for crushing of ordinary rock in smooth steel crushing rolls?

   A. 16°
   B. 32°
   C. 40°
   D. 46°

8. For crushing of solids, the Rittinger’s law states that the work required for crushing is proportional to __________________?

   A. The new surface created
   B. The size reduction ratio
   C. The change in volume due to crushing
   D. None of these

9. Work index is the gross energy (kWh/tonne of feed) necessary to reduce a very large feed to such a size that 80% of product particles will pass through a 0.1 mm screen. The value of work index determined for wet grinding should be multiplied with ______________ to get the same for dry grinding?

   A. 1.0
   B. 0.5
   C. 1.34
   D. 4.34

10. Half the angle of nip, (α), for a roll crusher is given by (where, dr, dp and df are diameters of crushing rolls, feed particles and rolls gap respectively) ?

    A. cos α = (dr + dp)/(dr + df)
    B. cos α = (dr + df)/(dr + dp)
    C. tan α = (dr + dp)/(dr + df)
    D. sin α = (dr + dp)/(dr + df)