A. Magnesite
B. Chrome
C. Silica
D. Fireclay
Related Mcqs:
- A furnace is made of a refractory brick wall of thickness 0.5 metre and thermal conductivity 0.7 W/m.°K For the same temperature drop and heat loss, this refractory wall can be replaced by a layer of diatomaceous earth of thermal conductivity 0.14 W/m.K and thickness ______________ metre?
A. 0.01
B. 0.1
C. 0.25
D. 0.5 - Minimum temperature upto which water can be theoretically cooled down in the cooling tower by evaporative cooling is equal to the ______________ temperature of air?
A. Wet bulb
B. Dry bulb
C. Saturation
D. Dew point - The heat released by cooling one mole of copper from 400 K to room temperature (300 K) is (assume : Cp of copper is 23 J K-1mole-1) ?
A. 2300 J
B. 4600 J
C. 230 J
D. 2.3 × 106 J - Temperature of hot gases flowing in a pipe is measured by a thermocouple inserted in the thermal well. The thermal well made of ______________ will facilitate the most accurate measurement of the temperature ?
A. Copper
B. Steel
C. Aluminium
D. Brass - The boiling & freezing points on a newly defined temperature scale in degree ‘D’ are 400°D & 100°D respectively. The temperature reading corresponding to 60°C on this new temperature scale will be equal to _____________ °D ?
A. 140
B. 180
C. 240
D. 280 - Heating the Hypo-eutectoid steels to 30°C above the upper critical temperature line, soaking at that temperature and then cooling slowly to the room temperature to form a pearlite & ferrite structure is called_______________________?
A. Tempering
B. Hardening
C. Annealing
D. Normalising - The ratio of thermal & electrical conductivity is same for all the metals at the same temperature; and at around room temperature, this ratio is proportional to(where, T = absolute temperature, °K) ?
A. T
B. 1/T
C. T2
D. 1/T2 - Principal alloying elements of cast tool alloys which have very high wear resistance & high temperature strength are ?
A. Cobalt, chromium & tungsten
B. Cobalt, chromium & nickel
C. Molybdenum, tungsten & chromium
D. Cobalt, zirconium & molybdenum - _______________ is the hardest oxide and is hence used where high wear resistance at high temperature is required?
A. Beryllium
B. Zirconia
C. Alumina
D. Magnesia - Evaporative cooling process employs a combination of cooling and humidification in which the____________________?
A. Sensible heat is added
B. Sensible heat is removed and the latent heat is added
C. Latent heat is removed
D. Sensible heat is added and latent heat is removed
