A. instantaneous and rapid burning of the first part of the charge
B. instantaneous atuo iginition of last part of charge
C. delayed burning of the first part of the charge
D. reduction of delay period
E. all ot the above
Related Mcqs:
- In diesel engine the diesel fuel injected into cylinder would burn instantly at about compressed air temperature of____________________?
A. 250°C
B. 500°C
C. 1000°C
D. 150CPC
E. 2000°C - High carbon content in diesel oil used for diesel engine leads to_________________?
A. production of highly corrosive gases corroding the cylinder walls and exhaust system
B. excessive engine wear
C. damaging of both the storage tank and the engine
D. deposition on engine parts
E. none of the above. - A diesel engine as compared to petrol engine (both running ar rated load) is ____________________?
A. more efficient
B. less efficient
C. equally efficient
D. unperdictable
E. other factors will decide it - Diesel engine can work on very lean air fuel ratio of the order of 30 : 1. A petrol engine can also work on such a lean ratio provided__________________?
A. it is properly designed
B. best quality fuel is used
C. can not work as it is impossible
D. flywheel size is proper
E. engine cooling is stopped - The output of a diesel engine can be increased without increasing the engine revolution or size in following way_________________?
A. feeding more fuel
B. increasing flywheel size
C. heating incoming air
D. scavenging
E. supercharging - The specific fuel consumption of a petrol engine compared to diesel engine of same H.P. is_______________?
A. same
B. more
C. less
D. less or more depending on operating conditions
E. unpredictable - The ratio of useful power; engine friction exhaust gas losses; cooling water, air and oil losses for a diesel engine is of the order of____________________?
A. 5:25:30:50
B. 25:35:5:35
C. 25:5:10:60
D. 40:30:15:15
E. 25:5:35:35 - To reduce the possibility of knock in the C.I. engines, the first elements of fuel and air should have_______________?
A. high temperature
B. high density
C. short delay
D. reactive mixture
E. all of the above - In order to prevent knock in the S.I. engines, the charge away from the spark plug should have___________________?
A. low temperature
B. low density
C. long ignition delay
D. rich mixture
E. all of the above - In a typical medium speed 4-stroke cycle diesel engine the inlet valve_____________________?
A. opens at 20° before top dead center and closes at 35° after the bottom dead center
B. opens at top dead center and closes at bottom dead center
C. opens at 10° after top dead center and closes 20° before the bottom dead center
D. may open or close anywhere
E. remains open for 200°.