i) column carries axial load only
ii) space between the two main components is not very large
iii) column is eccentrically loaded
The correct answer is
A. only (i)
B. only (iii)
C. (i) and (ii)
D. (ii) and (iii)
Related Mcqs:
- The heaviest I-section for same depth is_________________?
A. ISMB
B. ISLB
C. ISHB
D. ISWB - Efficiency of a riveted joint, having the minimum pitch as per IS : 800, is_________________?
A. 40%
B. 50%
C. 60%
D. 70% - The actual thickness of butt weld as compared to the thickness of plate is usually________________?
A. more
B. less
C. equal
D. none of the above - The range of economical spacing of trusses varies from________________?
A. L/3 to L/5
B. L/4to2L/5
C. L/3 to L/2
D. 2L/5 to 3L/5 where L is span - Area of openings for buildings of large permeability is more than_________________?
A. 10% of wall area
B. 20% of wall area
C. 30% of wall area
D. 50% of wall area - The mechanism method and the statical method give__________________?
A. lower and upper bounds respectively on the strength of structure
B. upper and lower bounds respectively on the strength of structure
C. lower bound on the strength of structure
D. upper bound on the strength of structure - For rivets in tension with counter-sunk heads, the tensile value shall be____________________?
A. reduced by 25 %
B. reduced by 33.3%
C. increased by 25 %
D. increased by 33.3 % - Other conditions being same, the load factor in indeterminate structures is_______________?
A. equal to load factor in determinate structures
B. more than the load factor in determinate structures
C. less than the load factor in determinate structures
D. unpredictable - Steel tanks are mainly designed for_______________________?
A. weight of tank
B. wind pressure
C. water pressure
D. earthquake forces - If the 20 mm rivets are used in lacing bars, then the minimum width of lacing bar should be______________?
A. 40mm
B. 60mm
C. 80mm
D. 100mm
