A. 3t
B. 4t
C. 6t
D. 8t
where t = thickness of the batten plate
Related Mcqs:
- In moment resistant connections, the moment resistance of riveted connection depends upon________________?
A. shear in rivets
B. compression in rivets
C. tension in rivets
D. strength of rivets in bearing - The use of tie plates in laced columns is_________________?
A. prohibited
B. not prohibited
C. permitted at start and end of lacing system only
D. permitted between two parts of the lacing - As per IS : 800, for compression flange, the outstand of flange plates should not exceed________________?
A. 121
B. 161
C. 201
D. 251where t = thickness of thinnest flange plate
- Rivets connecting flange angles to cover plates in a plate girder are subjected to_________________?
A. horizontal shear only
B. vertical load only
C. both (A. and (B.
D. none of the above - The allowable tensile stress in structural mild steel plates for steel tank is assumed as________________?
A. 95.0 MPa on net area
B. 105.5 MPa on net area
C. 105.5 MPa on gross area
D. 150.0 MPa on gross area - The minimum thickness of plates in a steel stack should be___________________?
A. 4 mm
B. 5 mm
C. 6 mm
D. 8 mm - Pitch of tacking rivets, when double angles connected back to back and acting as tension members should not be more than_________________?
A. 500 mm
B. 600 mm
C. 1000 mm
D. 300 mm - The maximum slenderness ratio of a steel column, the design of which is governed by wind or seismic forces is________________?
A. 150
B. 180
C. 250
D. 350 - The effect of racking forces is considered in the design of_________________?
i) lateral braces
ii) chord members
The correct answer isA. only (i)
B. only (ii)
C. both (i) and (ii)
D. none of the above - The centrifugal force due to curvature of track is assumed to act on the bridge at a height of___________________?
A. 1.23 m above the rail level
B. 1.50 m above the rail level
C. 1.83 m above the rail level
D. 2.13 m above the rail level
