Assuming 8 bits for data, 1 bit for parity, I start bit and 2 stop bits, the number of characters that 1200 BPS communication line can transmit is__________________?

Related Mcqs:

1. _______________method can bring the locomotive to dead stop?

   A. Plugging braking B. Rheostatic braking C. Regenerative braking D. None of the above...

2. A series resonant band-stop filter consists of a 68 Ω resistor, a 110 mH coil, and a 0.02 µF capacitor. The internal resistance, RW, of the coil is 4 Ω. Input voltage is 200 mV. Output voltage is taken across the coil and capacitor in series. What is the output voltage magnitude at f0?

   A. 1.1 mV B. 11.1 mV C. 111 mV D. 200 mV...

3. The slope of a.c. load line is ______________ that of d.c. load line?

   A. The same as B. More than C. Less than D. None of the above...

4. In jaw crushers a motor has to often start against ____________________ load?

   A. heavy B. medium C. normal D. low...

5. For which of the following applications motor has to start with high acceleration ?

   A. Oil expeller B. Floor mill C. Lifts and hoists D. Centrifugal pump...

6. Among the logic families, the family which can be used at very high frequency greater than 100 MHz in a 4 bit synchronous counter is__________________?

   A. TTLAS B. CMOS C. ECL D. TTLLS...

7. Speed-time curve of main line service differs from those of urban and suburban services on following account_______________?

   A. it has longer free running period B. it has longer coasting period C. accelerating and braking periods are comparatively smaller D. all of the above...

8. In main line service as compared to urban and suburban service______________?

   A. distance between the stops is more B. maximum speed reached is high C. acceleration and retardation rates are low D. all of the above...

9. For proper amplification by a transistor circuit, the operating point should be located at the_____________ of the d.c. load line?

   A. The end point B. Middle C. The maximum current point D. None of the above...

10. In class A operation, the operating point is generally located_____________of the d.c. load line?

    A. At cut off point B. At the middle C. At saturation point D. None of the above...